2 male snaps in posterior plate.

[Jinsei[TK]]

Just have a quick question about the two male snaps that need to go in the posterior plate. I've looked, but it's very possible I missed it. I can't seem to find if there is specific measurements of where the two male snaps need to be in the posterior plate, or are they just an approximate placement?

 

Hope this makes sense

Thanks,

 

Spencer. 

[Sentry71[TK]]

http://www.whitearmor.net/forum/topic/31920-ukswraths-am-10-ata-bucket-build/#entry411443

 

"measure first hole to drill at 15mm, 2nd hole at 35mm" from edge.

 

I don't think there is a hard and fast measurement, but that is what Tony did on one build.