Modified m38a2 scope

[Clamps[TK]]

During a recent family visit in California, I have the pleasure to pick up a modified M38a2 from TK Bondservnt 2392 (Vern). I believe the mod is to remove the LED port or something like that and then it was fixed up with some Bondo.

 

There was a mismatch of paint in the middle area where the mod took place. I sanded down most of the paint so I can repaint consistently.

 

I am about to being a full resin build with this scope as my ANH scope. The blaster will have an alternate scope rail and resin scope to make it ESB ready.

 

I have pre-cut the site rail to rough length. No notches or bends yet until I gave the resin kit for proper measurement.

 

Below is how the scope looks as of today. Not much wil change for a while as my armour is due to arrive this week.'

 

Side View

 

 

Top View

 

 

Front View through the Glass

 

 

Front view (sideways)

 

Edited August 8, 2012 by chookaboom

[TK bondservnt[501st]]

yoda say far too smooth this scope should not be.

 

perhaps we shall not be a smooth scope then? hmm?

 

[Clamps[TK]]

It still has lots o bumpy Master Yogurt. I only stripped the paint I make it consistent color.

[bigironvault]

Very cool!