Nate Jangotat Posted April 30, 2012 Report Posted April 30, 2012 I am starting on my Doopy's E-11 and seen a tutorial for the scope rail, when I get there -just wondered if there was anyone who makes em? Just seems there is a gap in the market otherwise. please shoot me a PM if you know a guy or gal... Thanks Nate Quote
matt black Posted April 30, 2012 Report Posted April 30, 2012 Hi Nate. Problem is that for scratch built blasters the measurements are never going to be the same. It only has to be two or three mm out and the the rail would be too long or too short. I suppose it would work for someone to do a run for Deac Sterlings but as far as I know no one makes them. Quote
jkno Posted April 30, 2012 Report Posted April 30, 2012 Indeed, Rob and I encountered the length differences between the deac. Sterlings/MR Blaster and various fan made blasters - the MR/Sterling being a bit longer than some fan made ones - this being because of the end part of the blaster. The MR blaster has a steel rail, my Sterling has a bronze rail and have seen people using aluminum or plastic too. The best way would be to go to a hardware shop and get some metal after you measure up your own blaster, or at least ask someone to make it for your exact blaster dimensions. Quote
Nate Jangotat Posted April 30, 2012 Author Report Posted April 30, 2012 Thanks guys. I guess, I shall have to get my hacksaw out! Quote
matt black Posted April 30, 2012 Report Posted April 30, 2012 Here is a great tutorial by Billhag http://www.whitearmor.net/forum/index.php?showtopic=4697 Quote
bigironvault Posted April 30, 2012 Report Posted April 30, 2012 Hacksaw! It's not as hard as it looked. I was quite scared to do it but it worked out just fine for me. Quote
Nate Jangotat Posted April 30, 2012 Author Report Posted April 30, 2012 Hacksaw! It's not as hard as it looked. I was quite scared to do it but it worked out just fine for me. Inspired. Cheers Keith - I shall give it a go Quote
bigironvault Posted May 4, 2012 Report Posted May 4, 2012 Just make sure you clamp that puppy down while sawing... and erm, don't breathe in too deepy (depending on what metal you got)... haha Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.