Jump to content

Xanthais

Member
  • Content Count

    72
  • Joined

  • Last visited

About Xanthais

  • Rank
    Sergeant
  • Birthday August 12

Contact Methods

  • Website URL
    www.liningup.net

Profile Information

  • Gender
    Male
  • Location
    Riverside, CA.

Standard Info

  • Name
    Craig
  • 501st Unit
    Southern California (IE Squad)

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Hmmmm... I've been looking at their DT kits too, and have been told the opposite. Are there other makers out there that have them?
  2. Yeeeeeeeah. I'll post some pics after the 1st in my thread. Have some serious gaps in my chest/ab plate. Sent from my MSE-6 droid using Tapatalk
  3. I ahhh....might have a problem with my ATA. I'm 6'-4", but thankfully haven't been able to do much of anything to mine (as you know), so might be able to sell it at cost. Sent from my MSE-6 droid using Tapatalk
  4. I'm still here. Hahahaha. End of the year is always insanely busy for me. I should be picking things back up after the 1st. Nice Staind reference. [emoji41] Sent from my MSE-6 droid using Tapatalk
  5. I haven't even touched mine yet. They're scary, and the ABS is thick af too. Sent from my MSE-6 droid using Tapatalk
  6. "Nuts!" was Belgium, December 1944. LOL Sent from my MSE-6 droid using Tapatalk
  7. Actually, that helps a TON. The upward slope is definitely there. I'll wait to cut the notches, however, until it's all fitted. Just to ensure it's right. Sent from my MSE-6 droid using Tapatalk
  8. Hmmmm....I have no lower notch cutout lines. There is a raised return edge on one side, but its flat on the other. Sent from my MSE-6 droid using Tapatalk
  9. @Rat, thanks man! Any advice on the pics and trim lines I posted yesterday? Sent from my MSE-6 droid using Tapatalk
  10. Is there a right-side-up on the Kidney, or is it meant to be either side up? Also, I might have to go with snaps system instead of brackets, since my waist size might mean I have to trim all return edge from kidney to it meets with the ab plate for Centurion requirement, leaving no attachment point for brackets. Will have to wait and see how it all fits when taped on for initial pre-sizing with the undersuit.
  11. Boy, first lack of pics, now a plethora! Back piece. Do I leave return edge (Blue line), or take it all off and cut to the Red line? Left pic is blue line cut. Right pic is interior other side, not yet trimmed at all. Again by the look of the left pic, I'm guessing all the way to the red line is what I want, yes? Sent from my MSE-6 droid using Tapatalk
  12. Same question on the cod. Red or Blue wire? On this one I'm assuming its the red line, but I want to be sure before I start trimming. Sent from my MSE-6 droid using Tapatalk
  13. For the buttplate, do I cut along the red line, or the blue? Sent from my MSE-6 droid using Tapatalk
  14. Copy that, thanks! Sent from my MSE-6 droid using Tapatalk
  15. Are the shins held up by anything other than the boots? I know I've seen velcro thigh suspension systems, but cant recall anything for shins, and a search hasn't helped. Thanks! Sent from my MSE-6 droid using Tapatalk
×
×
  • Create New...