Jump to content

Robotster

501st Stormtrooper[TK]
  • Posts

    7
  • Joined

  • Last visited

About Robotster

Profile Information

  • Gender
    Male

Standard Info

  • Name
    Steve
  • 501st ID
    11238
  • 501st Unit
    Midwest Garrison
  1. TK11238 is my small tribute to Mr Lucas and his remarkable movie THX1138. 11238 was as close as I could get.
  2. I am looking for a pair of boots for my Dooku Costume. Because I have a fairly close resemblance to Christopher Lee, I am shooting for top level certification. This cert level requires an equestrian style pull-on boot (without zipper). Has anyone run across a source for this type of boot. I am really struggling with sourcing this boot and any help would be appreciated.
  3. I noticed that when I put my best blaster in the holster, it did the same exact thing as your picture. It is basically a combination of two problems, and both need to be addressed before the tilt/flop issue is resolved. First: Many holsters are made of very thin material. Thicker holster material is absolutely necessary to stiffen the holster. Second: Most blasters, when loaded into the holster, are top-heavy causing them to flop and/or tilt. I recently built an DLT-19 rifle. My standard "carry" blaster is a very nice design and has some heft to it. It flopped over in the holster even though I upgraded my holster. Since the blaster should be in the holster when carrying the rifle, I needed a solution. So I purchased a very inexpensive blaster (Hasbro?) and painted/weathered it. It looks just fine in the holster and weighs just a few ounces and sits in the holster perfectly.
  4. Very nice build. I just got a bare bones DLT19, but I need to source the bipod for my 3D printer. Where can I source the STL files for the bipod? Checked Thingiverse - no luck.
  5. Steven Jackson TK-11238 FISD: Robotster Midwest Garrison Armour: Anovos Helmet: Anovos Blaster: Resin Height: 5'11" Weight: 210lb Boots: TK Boots Canvas Belt: Rob Kittell Canvas Belt Handplates: Anovos Neck Seal: Anovos Holster: Anovos
  6. Requesting 501st access change Ready to apply for EIB status. Member ID: TK 11238 http://www.501st.com/members/displaymemberdetails.php?userID=21098 Thanks
  7. Just an FYI, I messed up a bit and needed a new forearm strip. I purchased an Evergreen #9060 styrene sheet. The Evergreen styrene is noticeably whiter than the Anovos white.
×
×
  • Create New...