Darth Nerdius

Yup. Industrial Velcro is the shiz and what I used.

Here is my setup (with Rom/FX) Works good and is balanced and LOUD

Could I please ask is the use of the RT-Mod helmets for Elite Status OK?

But is that required for elite status?

I haven't done the butt plate split yet... I might redo the shims and make them slightly bigger as I took too much off when I trimmed and now I have the technique down.

Here are some dodgy pix I just took so you can see a bit closer. I need to sand the shims more and paint the rivets but then again I might just do the shims again differently. Either way you get the idea of what I am trying to do. Also the here is a pic of the face so you can see lenses + blaster.

Hey all, Working on what I need to do for elite status and would value some feedback. Here is a side, a front and a back picture. Since this time I have fixed and shortened the shims to have a better curve (so they don't stick out awkwardly at the sides), riveted the ABS belt to the canvas belt and made the torso sit higher on my body. Other than that these pics are fairly accurate (what I submitted for my 501st a few weeks back hence the red background albeit sloppily dressed). What I know I need to do. * Fix the MRCE Chin/get an AP Bucket. Already done the teeth but maybe not enough? * Split the rear torso. I am not sure why, but the split in my rear torso is right in the middle of where the canvas belt sits. Is there any issue to cutting it about an inch under the line for cutting so it lines up with under my belt as it is meant to?? Also is this blaster OK for Elite? Can anyone think of anything else that needs work on this kit to get to elite other than the above? Anyone see anything I can make better or need to do? Opinions welcome!

As you can see my noggin is long and skinny

here's how I did mine. Go to this thread if you'd like some of this stuff: -------------

Who me?

thanx Only things I have to do is fix my MRCE chin seam and cut the bottom part of my back torso and I can do just that not gunna though.......yet.

Sounds reasonable But ya didn't ignore me I have included in my last post

heya whoever TK 5508 is now 501st approved. Upgrade me! http://www.501stlegion.org/members/display...hp?userID=10108

Yeah the foam came from Derek (D-Mac) and is chopped up knee pads. I can thoroughly recommend as it is very good stuff and he is a nice bloke too. I think he is still doing the foam from memory or at least I hope so as I might need some for my TB lid I am probably going to remount it in the chest actually as the short thing is of concern. But what I am doing is getting my TK to a point where I can use it and then I am going to refine the hell out of it as people do. All sorts of different things I want to do, but there is no point refining it until I am 501st approved and have a full set of armour I can wear

Yup, I ordered and my classic arrived last Monday and I am well chuffed let me say It's a superb piece of kit...Painful to mount in a helmet, expensive (more than the bucket) but noooice. This is the pilot version (ie gaffer tape until I am sure) of how I have done mine. I actually cleaned it up and it is very effective so I am thinking of buying white gaffer and calling it the production mounting so to speak The helmet is constantly changing until I am happy with the config of it...best thing I did was use industrial velcro on everything in the helmet so I can move it all around as needed ------