I need major help with my ear pieces (this is my third attempt on trimming the ATA ear pieces)! What is the easiest way to trim them? Which ear piece goes on the left and which one goes on the right? It seems like Ear Piece B is larger than Ear Piece A, why is that? Any good tutorials out there? Thanks!
Thanks to Carlos who sent me his extra pair when I messed up both of my ear piece pairs!
Ok, I am about to glue on one of my Ab button plates! How does it look? I am going to attach it using the E-6000 glue and clamp it down with rear earth magnets.
-----------
I like the idea of using screws on the neck tubes instead of rivets. Is the blue painters tape in the correct position so that I can drill my holes for the screws?
Alright, the first 2 rivets are in! Here are the pictures! What are your thoughts? The blue painters tape is where I plan to put in the other 2 pop rivets. Will I have to worry about the bottom screw of the ear piece?
Ok, thank you! So is this what the rivet should look like when all done?
Front (Outside of helmet):
Back (Inside of helmet):
Thank you all so much for the help! Sorry if I am a little too nervous! Star Wars is my life and I don't won't to mess it up with one little mistake!
Sounds good! With the pop rivet, I drill the hole, put the rivet in, put a washer on the inside of the helmet around the rivet, and then use the gun..correct?
Thanks!
Thanks for the suggestions, I think I am going to buy a replacement, but what about the other ab plate button panel? How much do I trim it? Should it lay flat? What is the best tool for the job?
------------
I am getting very frustrated with my build! I can't get these button plates to fit into their designated spots!
PLEASE HELP!!! This is really pushing my buttons (pun intended)!!!
Ok, so I have been trimming my helmet and I need to know if I need to trim more. Here are pictures of my helmet so far! Let me know if you need to see more pictures to make more accurate advice! Thanks for the help!