Requesting for some help on chest and back plate return edges!

[al3x_h.xm]

Hey there! Just wanted to get some opinions on the return edges I plan on trimming onto the back and chest plate of my ATA kit. 

 

Since these pieces are some of the most important on a TK suit, I'd like to make sure they look great!

 

For the chest plate I have traced out two potential cutting areas: the above one would result in a 5mm return edge, and the below area follows what seems to be a molded line on this piece. 

 

For the back plate, I traced the edge of the mold before it curves down significantly.

 

 

Thank you all for your guidance in advance!

Edited April 28, 2025 by al3x_h.xm
Adding "requesting for" to the title

[Sly11[Admin]]

Hi Alex, think we answered this one over on your other post

[al3x_h.xm]

6 hours ago, Sly11 said:

Hi Alex, think we answered this one over on your other post

Hey @SLy11, definitely! Just wanted to make sure it passes the "eye test" ;)