gSkruBg[TK] Posted July 17, 2022 Report Share Posted July 17, 2022 Hello there. I'm wrapping up my ANH TK stunt build, and I noticed that the CRL has the little nub on top of the TD looking a bit more like a donut than mine. Was mine cast inside out? Thanks for any help. Quote Link to comment Share on other sites More sharing options...
gmrhodes13[Staff] Posted July 18, 2022 Report Share Posted July 18, 2022 Looks like a very soft pull, not much definition in the O. This is how it should look. You could speak to the supplier of yours and see if they have a better one, or speak with your GML as to if it will be an issue for approval. You could also with some practice k(a lot if using a heat gun) add some heat just to that area, add washers behind and push in the dimple. Quote Link to comment Share on other sites More sharing options...
gSkruBg[TK] Posted July 18, 2022 Author Report Share Posted July 18, 2022 I got this kit for dirt cheap. So I don't really know the supplier. Thanks for the tip on heat forming! 1 Quote Link to comment Share on other sites More sharing options...
MaskedVengeance[Staff] Posted July 18, 2022 Report Share Posted July 18, 2022 I myself am a thermal detonator addict, and as Glen mentioned, if you're absolutely stuck with using the plate you have, perhaps placing a washer sized to match the "donut" shown in the photo behind the plate (assuming you can remove it from the pipe), heating, then pressing in the dimple through the washer hole might work. Below are some links to my detonator posts: Thermal Detonator Part 1 Thermal Detonator Part 2 Thermal Detonator Part 3 [coming soon!] Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.