LTM[TK] Posted May 10, 2018 Report Share Posted May 10, 2018 Need some help/advice on cutting the forearm taper. I am building one of the new AM kits and just want to make sure I am looking at this the correct way before I make any cuts, I do have thin wrists, but the opening is large enough to slip my hand through. Do I keep the cuts (and the cover strips) at a 90 degree angle to the outside ridge? Below I am using a ruler to show where I think I should cut (equal distance of the opening at a 90 degree). Or should I cut off equal amounts on both sides? Wrist end Elbow end Quote Link to comment Share on other sites More sharing options...
Andrew77 Posted May 11, 2018 Report Share Posted May 11, 2018 I have the AM suit as well and I ruined my forearms because my measurements where only taken with my arms resting. As soon as I tried to bend them I had no room in the forearm or biceps. Make sure you measure your forearm and biceps flexed or in a position that you hold the weapon in - once you cut you can’t put it back onGood luckSent from my iPhone using Tapatalk 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.