rbst[TK] Posted February 14, 2018 Report Posted February 14, 2018 (edited) Hello all. I have an ANOVOS assembled set of armor that I purchased second hand. It needs ALOT of work. I am 5'-9" and the legs pieces are a little long. I am thinking of trimming about an inch off the bottom of each shin piece. Is this the best way to give myself some room where the pieces meet at the knee? Any advice on the best way to go about this would be greatly appreciated. See attached pic for reference. I can upload more pics if needed. Thanks! Edited February 14, 2018 by rbst Wrong spelling Quote
TheSwede[TK] Posted February 14, 2018 Report Posted February 14, 2018 25 minutes ago, rbst said: Is this the best way to give myself some room where the pieces meet at the knee? If your knee is centered then yes, don`t want the shins to short 2 Quote
ukswrath[Staff] Posted February 14, 2018 Report Posted February 14, 2018 The lower shin as Daniel mentioned and another option is to trim the tops of the thighs. Quote
rbst[TK] Posted February 15, 2018 Author Report Posted February 15, 2018 Thanks for the replies. I also have a pre assembled ANOVOS belt that I am going to replace with a belt from imperial issue. Any advice on where to find replacement attachment hardware for attaching ABS to new belt? Quote
TheSwede[TK] Posted February 15, 2018 Report Posted February 15, 2018 pop rivets (hardware store) would work Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.