PGPDPig[TK] Posted January 31, 2014 Report Posted January 31, 2014 Newbie here, I have a couple of questions about the holster and the belt attachment. From reading some of the threads I noticed that there were comments about the width of the straps holding the holster to the belt. I want to say I heard 20mm. I have looked around for a while and I haven't seen any measurements on any of the posts or in the EIB or Centurion requirements section. Also I was looking to see if there was any requirements on the positioning of the rivets that hold the straps to the belt? Like, do the need to be attached at the bottom on the belt, middle etc. I saw that it has to be 1 rivet to attach it, but I couldn't find anything about the placement of the rivet. I'm eventually going to try for Centurion, so I'm looking to attach the holster to the belt for Centurion level now, so that way when I apply for it, I won't need to make any kind of corrections. I figure you only get one shot at this, because once you attach the rivet, that's it. Any ideas of where to look so I don't mess this up. Thomas 1 Quote
PGPDPig[TK] Posted January 31, 2014 Author Report Posted January 31, 2014 One more question that I forgot to ask. It's about the color of the straps that hold the holster to the belt. I have seen some that are black and some that are tan. Is there anything in the requirements that it has to be one color or the other or is that more of a personal preference? Thomas Quote
The5thHorseman[501st] Posted January 31, 2014 Report Posted January 31, 2014 Straps to the belt should be 20mm. They can be either black or tan: About the measurements: 1 Quote
PGPDPig[TK] Posted February 1, 2014 Author Report Posted February 1, 2014 Thanks for the information. That helps out greatly. Thomas Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.