ARC982106

I am 5'7 an entirely unable to bend my legs/walk. Definitely have to shorten the thighs down. Any recommendations? I dont think i'm capable of remolding the return edges.

It probs would yield a better finish than neoprene, and be gapless. Thanks for the suggestion.

I'm trying to line my helmet, I'm using some black neoprene liner, but unfortunately, it is a pain to separate the foam from the adhesive and it does not line up properly inside the helmet, as it doesnt flex or curve well. What are some good alternatives?

I have to figure a way to remove the dried sugru and I think I'll just try a different method. I don't want to put the original film back in, but I'm thinking this Lens mounting is beyond my skill level, and definitely has me frustrated to the point asking for help. I appreciate the advice/suggestions.

I'm not sure what else can be done other than trying to sand all the sugru off and trying again, but I still run into the problem of the sugru not being strong enough to hold the bolts. I'm frustrated with the process as a whole because I've spent a month trying to get the lens to mount and work right.

I found a lens install guide created by Kamikaze, I followed his tutorial but unfortunately, the Sugru used to anchor the mounting bolts in position simply wasn't strong enough once the pressure of the lens was put on it. I had to use much more Sugru to get the bolts to stay anchored strongly causing the lens to not be able to sit flush, leaving a gap. Will this be too much gap?

Thank you for this awesome tutorial, I used this for my lenses and unfortunately, the sugru just doesn't seem strong enough to hold the bolts in place, so I had to use almost triple the amount causing a large gap at the top of the lens, but I believe it should be approvable.

I need to take the helmet apart so I can have better accessibility, I'm not sure if these are buttons or rivets that cannot be removed, does anyone have experience with taking the helmet apart?