Vader's Wingman

Hello everyone, I am looking for a reasonably priced experienced commission builder for an Imperial Surplus FOTK that I am in the process of getting. I don't have the space in my apartment and the time to build one myself, so I am reaching out to others who might be able to. Please send me a message through White Armor. Thanks, Ted TK-6298

Does anyone have a visual installation guide for the ST strapping system from Imperial Boots? There were no instructions included that came with my order. Upon comparing the set that came with my Anovos ST kit, the one from Imperial Boots as fewer pieces. Not sure what goes where on my armor kit Thanks.

So for this 850 Armor yoke piece, I've been applying a thin layer of Bondo then sanded it down using 3M 220 paper. I've already done this 9 times. But I noticed that there is always a stress fracture crack when the armor is handled and I can't seem to get rid of them! I haven't painted yet but I'm wondering if it's the type of bondo that I am using or is something like this expected to happen? The Bondo that I'm using is "Glazing & Spot Putty". What other types of Bondo are builder's using? Once painted, I'm sure that the cracks will reappear again and I'm starting to get annoyed with the entire process! Anyone have any suggestions with this? Thanks.

Hello Team, Whether going for the EIB or Centurion program, is there a preferred choice of armor maker to go with? I assume the Anovos ANH hero set would have lower expectations than other sets of armor and wouldn't be that great to use??

I'm in the process of installing a pair of 2w mini speakers with the amp inside of my fiberglass helmet port openings. Any suggestions on how to cut down on the terrible feedback I'm getting when the volume is turned up? I tried placing foam insulation around the speakers and tried using 3 different types of head mics but not much improves. How else are builders doing this?

I came across a piece of ribbed material that I might be able to use to construct my own set of gaskets. Does anyone know how wide the spacing inbetween the ribs should be? Does the material need to be shiny like latex is or is semi-shiny cloth sufficient to use?

Hello Folks! Has anyone ordered and assembled their own gaskets from Imperial boots? Is this material and the details satisfactory to use? It says 8 gasket sheets should be able to complete a FOTK gasket system. Is the pic attached the actual piece received or is this something that was sewn and ready to go?

TK-6298 requesting 501 access: https://www.501st.com/members/displaymemberdetails.php?userID=11412