Hey panda, I can't PM you but could you scope out my build thread and see if I may need a trim on my thighs. Maybe about an inch or so. And should I see about trimming my thighs as you have?
So thighs at 20 and shins at 25mm. I'll make the adjustment today. What size drill bit should I use for my mic tips? I have them but no holes drilled out.
Everything is trimmed down to the "ballpark" of measurements. 16mm biceps/forearms(F/R) thighs and shins are at 20mm(F)/25mmĀ® do you think I should go lower on the back of the shins? The thighs are almost perfect but could use a very slight trim to fit better. As well as trimming the shins/thighs some to accommodate my legs. I have the right screws but my ears need repair or replacement. They aren't as easy as I'd hoped for. I'm gonna try again on the same pair and get them as flush as I can with the helmet. I just received my mic tips today so I'll get to that when I get home on Monday.
That's what I'm going with. I just need to get my snaps together in the plates. Could you see my chest and tell me if it's too wide? Would I need to add elastic to the sides to bring them in? I know lucnak said that it was a bit wide on the edges.
I have my front thighs at 25 and the backs at 20mm. I'll be putting foam in there to help keep it stable. The sides aren't bent the chest and back are just hanging by tape. My ab is pretty tight around should I loosen that up?
I feel I may need to trim the tops of the thighs down slightly. Everything fits nicely. My shins were loose, really loose. They turned around on me. Any fix to that or should I apply padding inside?