Jump to content

Recommended Posts

Hello everyone,  I am doing the final fitting of the thighs and have run into an issue.  The tops are very close or are touching the butt plate. I have looked at several pictures of how this is suppose to look and noticed the edge is different based on who produced the armor.  

 

My question is  - can I trim the thighs as I have marked in my picture or should I just trim an inch or so and keep the same design?

 

thank you in advance for your suggestions.

 

 

 

 

 

IMG_8694.thumb.jpg.1df65c49665b2be8f7444b5496618173.jpg

 

Edited by jkarge
added jpg

Share this post


Link to post
Share on other sites
4 minutes ago, jkarge said:

Hello everyone,  I am doing the final fitting of the thighs and have run into an issue.  The tops are very close or are touching the butt plate. I have looked at several pictures of how this is suppose to look and noticed the edge is different based on who produced the armor.  

 

My question is  - can I trim the thighs as I have marked in my picture or should I just trim an inch or so and keep the same design?

 

thank you in advance for your suggestions.

 

IMG_8694.HEIC

Can't open the image

Share this post


Link to post
Share on other sites

Answer is yes

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×