XiliX Posted February 5, 2016 Report Share Posted February 5, 2016 Just unsure. <br><br><br> Thanks for any and all replies <br><br> XilliX Quote Link to comment Share on other sites More sharing options...
tkrestonva[TK] Posted February 5, 2016 Report Share Posted February 5, 2016 One of two ways: - The easiest way is to look for the square-shaped kidney notch (which not every kit has). If it has that, then that goes toward the bottom. - If not, you'll have to look at the shape as seen from the side. It should have the same curvature that a normal human spine does. Quote Link to comment Share on other sites More sharing options...
XiliX Posted February 5, 2016 Author Report Share Posted February 5, 2016 I have an ATA kit. One side is a smooth curve. The other side has some sharper curves towards the outside edges. When I say sides, I mean the horizontal sides. Quote Link to comment Share on other sites More sharing options...
Coastertk[TK] Posted February 5, 2016 Report Share Posted February 5, 2016 Hold the kidney plate vertical and place the back plate on top of it, leaning it back about 20 degrees or so. If it doesn't look right, flip the kidney plate over. One of the two options will look much better. Go with that. Quote Link to comment Share on other sites More sharing options...
XiliX Posted February 5, 2016 Author Report Share Posted February 5, 2016 Thanks Jay. That answers my delima. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.