I need to trim down some parts of my FX, since I'm a little dude! It's been many years since I made all my cool little models, so my hobby skills are long extinct. So humor me with this basic question!
Do most of you just use the old reliable Xacto and then sand the edge (and then give it a return with a hobby iron if you're hardcore... my iron is in the mail!) Is there a good "guide" to go by while trimming to keep the chest trimming even on either side? I'm thinking maybe just scotch tape a straight edge on top of the chest plate to where I want to trim down to on either side (especially to shorten the inaccurate "wings" that the FX chest has on the ends, going too far down relative to the middle of the bottom of the plate...) My biggest concern is making one side of the plate too short for the other. At which point I'll go back and do the other side again to make it even, and go too far.. so I'll go back and do the other side of the plate again, ad nauseum. Kinda like when I try shave my sideburns
I have the same concern about the thighs, actually.
Thanks y'all!