hondutrooper

Any tips for the mic tips placement? There isn't a defined flat spot to put the tips on. Does this look about right?

Thanks for the tip. Would mineral spirits be needed too?

So I finished the teeth and ended in a point past the last indentation...thoughts?

Made some progress after a long break... Painted the inside black Cut the trim. Is this supposed to be straight or is at an angle OK? Painted the vocoder as best I could...does it look good? Started painting the teeth...but wasn't sure if I needed to paint the last tooth? Cut out that last piece?

Heat gun or hair dryer?

Made some progress on the helmet. Everything fit pretty smoothly with the exception of the left ear. Any tips appreciated on how to close that gap more. I'll play around with it more and see how close I can get it. Teeth Cut out Right ear - small gap Left ear - larger gap that I want

sounds like a great idea...would like to see that built

Thanks for the tips. I figured trimming both sides would be best but I wanted to make sure. Will work on that tonight.

Did some more trimming today. Dont want to do any glueing yet. Moved to the forearms but stopped since I had questions and didn't want to mess things up. Two questions- 1- When trimming to fit my forearms, can I trim from the both the interior and exterior parts? Or am I limited to interior only? 2- The forearms seem long for me...can I shorten at the wrist? What is the guideline for length? Thanks!

Got it...dimple for left arm. I can't tell if the outer parts are symetrical or not. Anything I should be looking for on the pieces?

This is my first build. I'd like to start off by apologizing for all the questions, but seems like the community is very helpful. Going to start on the biceps. Trimmed the returns already, will start trimming sides to fit. So here's the first silly question...what side goes where? From other builds I gather that the dimpled piece is interior right. What about the outer pieces?