Jump to content

stearman_325

Member
  • Posts

    7
  • Joined

  • Last visited

About stearman_325

Standard Info

  • Name
    Kevin
  1. Hello everyone, I am having trouble deciding between 1.5mm TM Armour and 2.0mm. I have a full set of AP Armour, and I have an RS bucket. The detail on the RS is fantastic, but I really like the rigidity of the 2.0mm AP Armour. I just worry about sacrificing detail for strength. Can someone point me toward some pictures of 2.0mm TM Armour? I've seen numerous TM build threads, but I can never tell if I'm looking at 1.5mm or 2.0mm pictures. Those of you with TM Armour; what was your reasoning for going one way or the other, and which way did you decide to go? Thanks a lot for any assistance or guidance on this. Kevin
  2. I thought the same thing. Unless there was $350 worth of glue included, I didn't understand the great deal part. Sent from my iPhone
  3. They look a little high. Can you lower them down a little bit, and then tuck the bottoms in? Sent from my iPhone
  4. Apparently Bestine is a tradename for hexane. Sent from my iPhone
  5. Not benzine. Bestine. -------------- Sent from my iPhone
  6. Bestine works better than anything. It's basically thinner for rubber cement. Once you try it you will never be without some. Sent from my iPhone
  7. I have a set of AP armor which I like very much, but I think the thermal detonator is a little small. The diameter is 2 3/8 inch. I think I read somewhere that the original parts were 68 mm. What is the overall length with the end caps in place? I have some 2 1/2 inch gray ABS tube from Plastruct, which is a lot closer to 68 mm than 2 3/8 inch. I plan to make a pattern to vacuum form new end caps. Just want to make sure I get the overall length right. Thanks for any input. Kevin Sent from my iPhone
×
×
  • Create New...