ZeroCooL

ok brilliant, thats what i was going to do another question then... the inner diameter of the doopys E11 is ALOT narrower than on the original sterlings. So is it acceptable that i will have a bolt through sitting quite deep inside the ejector hole? as you look at it, say on the original doopys resin cast the bolt looks to be set in behind say 1.5mm of metal pipe, whereas the doopys resin is like 3mm, plus the inner tube they used to cast is another 1.5 or so, its going to be much deeper than the originals! Not sure what to do with it now hmmmmmmm

hey guys, hello from the UK Im currently doing my E11 build, and very similar to this with a fashioned bolt and charging handle which slides back etc. Ive found some 20mm UPVC pipe that fits inside the barrel perfectly... add a spring to the back and hey presto. However, rather than leaving the pipe from the end of the spring all teh way to the muzzle end, i intend to cut it back to a normal bolt size. But what have you guys put in front of your bolt, have you left a long pin or just sanded it flush? I wonder if i dont leave anything to stop the bolt moving too far down the barrel that the only thing holding it back is the charging handle...