Discharged_Mindriot

as you can see from the face on shot, the face plate has a little kink in it that makes the plate not so rounded on one side, I take when it is all lined up and fitted (Obviously I will have to take the eyes out to enable me to clamp & test) will this then resolve itself?

Do I need to trim the face plate at all, i.e. sides or top?

Sorry - uploaded to photo bucket now Its the right hand side I am concerned about - does this look right? Also - could anyone give me a guide as to where to cut this back section?

i dont really have any of these

You peeps on here really are stars! Alex - there is no defined line to cut to, i'll upload some pictures to show you

Hi All, Once again, I may have jumped in before fully doing research, and tbh - before I joined this here forum, I bought what I thought would be an fairly good quality lid kit from fleabay - from VT/General Veers whatever you want to call him. The plastic (ABS) is extremely thin in places and the lines are all over the place... I have been looking on here for tutorials on how to build, but I dont seem to be able to find any. I am particularly interested in the line which should cut which is covered by the ears/antenna on both the front plate and rear section... does anyone have a shot of this? http://cgi.ebay.co.uk/ws/eBayISAPI.dll?Vie...e=STRK:MEWNX:IT whoops..... I think now, with 2 duds..... i have now learned my lesson.... I will however, make them both, and see what they look like