Jump to content

mrpeterk

Member
  • Posts

    5
  • Joined

  • Last visited

Everything posted by mrpeterk

  1. Thanks gmrhodes13 & TK Spartan. I appreciate the feedback! Long live the Empire Peter
  2. Hello, My name is Peter and I'm doing my first build. My question is in regards to cutting the forearm return edges on the wrist side. I understand the CRL just says "No return edge on the inside of the front of the forearm is allowed." My mentor's armor is not AM and he wasn't 100% sure and wanted me to reach out to the community. I've looked though the forums really didn't find the answer I was looking for. Do I try and save the rounded edge of the hump part on top of the armor? Or is that still considered part of the return edge and I should cut it off? I think I can do it by using the dremel wheel and cutting half the return edge, then switching to the sander wheel and finishing it off. Thanks in advance! Peter
  3. Thanks for the reply Dracotrooper, I'm getting all the required pieces now. I'll update this post once I figure this all out.
  4. Hi and thank you for this awesome detailed post. I have one question. In reference to the directions " I then cut a piece of 22mm diameter 3mm walled clear acrylic tube to length and slid it into the receiver until it sat where the barrel would normally be. The 3D printed LED end cap was assembled and the unit was then placed through the hole at the mag well, and placed over the end of the acrylic tube. The wires for the LED were once again cut to allow them to be routed back to the counter box. " The parts list for barrel LED mount from Lee McCormack - Shadow Defense Systems on Shapeways. Which I confirmed from Shadow Defense is the LED and Acrylic Tube Support that they're selling, description shows "Designed for use with a (20mm OD, 18mmID Bore) Clear Acrylic tube." I'm just trying to clarify, Instead of 22mm clear acrylic tube should I instead get the 20mm? Or is there something I'm missing. I'm very new at this type of hobby. Thanks for patience. Shadow Defense link below for the LED and Acrylic Tube Support https://www.shapeways.com/product/MEX83SXWX/blastfx-e11-led-and-acrylic-tube-supports?optionId=64236933&li=marketplace
×
×
  • Create New...