Dezijan

Thanks for the advice. I will try the scissors as mentioned elsewhere. I have done the cut and score to snap off. It just doesnt seem to cut deep enough. When i go to snap off it almost bends the entire piece causing folds in the plastic. Maybe my cut technique is bad. Maybe the knife is dull. I will have to do a lot of sanding to smooth it out. Sent from my SM-G930P using Tapatalk

So I've seen mentions of using exacto knives and such to trim the pieces. I just started my anovos kit today, trimming the backplate and some chest pieces. I used both an exacto and utility knife. Perhaps i and not pressing hard enough or somthing. The pieces are very hard to cut. The trims i did do are messy and will require lots of cleanup and sanding. Is there something i am missing or doing wrong? Any recommendations before i end up destroying pieces?<br><br> Thanks,<br> DEZ