Chachi

February 15, 2023

Thanks again for all of the detailed info.

February 14, 2023

Thanks

February 14, 2023

So basically I'll have to remove the velcro, trim the overlapping piece that the velcro was on , then butt the 2 pieces together and finish off with a strip of ABS. 1 inch wide? I'll use the same concept of modification to the thighs, forearms and biceps.

February 14, 2023

Thanks for the detailed input!

John

February 13, 2023

Thanks for the response.

Shoulder bridges should be glued down at the front, can see velcro.

Remove velcro in front and glue. Free floating in back?

Belt needs to be fabric

Front is ok (Abs) what wraps around needs to be fabric (elastic) ?

Thigh cover strips should stop above the lower ridges, not continue to the bottom.

thigh cover strips lightly rounded before bottom? Answered below.

Rear thighs are overlapped and should be butt joined and cover strips.

so they "butt" together, then velcro is fine on the cover strip itself.

This is the same with the forearms and biceps, should be butt joined and cover strips

Same as above

Calves should cover outside over inside, your right leg is covering from inside over outside

Ok

Blue on an plate buttons looks very dark, should be French Blue #14

Ok

Holster should not be held on by loops, should be short straps attached to lower section of belt.

Ok

You do have a gap in the sides, ok for basic but would need to be reduced for higher levels.

Ok

Shins on rear should close from the outside over the inside so the opening is not seen from the outside.

Ok

Thigh ammo stop should not be curved on top, should be a straight corner, only curved on bottoms. Also looks like it is secured with screws in the bottom corners, should be attached in the top corners and on the lower ridge, should be held with cap rivets.