Thanks for the response.
Shoulder bridges should be glued down at the front, can see velcro.
Remove velcro in front and glue. Free floating in back?
Belt needs to be fabric
Front is ok (Abs) what wraps around needs to be fabric (elastic) ?
Thigh cover strips should stop above the lower ridges, not continue to the bottom.
thigh cover strips lightly rounded before bottom? Answered below.
Rear thighs are overlapped and should be butt joined and cover strips.
so they "butt" together, then velcro is fine on the cover strip itself.
This is the same with the forearms and biceps, should be butt joined and cover strips
Same as above
Calves should cover outside over inside, your right leg is covering from inside over outside
Ok
Blue on an plate buttons looks very dark, should be French Blue #14
Ok
Holster should not be held on by loops, should be short straps attached to lower section of belt.
Ok
You do have a gap in the sides, ok for basic but would need to be reduced for higher levels.
Ok
Shins on rear should close from the outside over the inside so the opening is not seen from the outside.
Ok
Thigh ammo stop should not be curved on top, should be a straight corner, only curved on bottoms. Also looks like it is secured with screws in the bottom corners, should be attached in the top corners and on the lower ridge, should be held with cap rivets.
Ok
Detonator clips too small
Ok
Thanks for the tips. I now have a good list to start.
John