Jump to content

stearman_325

Member
 View Profile  See their activity

  • Posts

    7

  • Joined

  • Last visited

 Content Type 

Posts posted by stearman_325

  1. TM Armour.... 1.5mm vs 2.0mm

    in Hard Armor (General Discussion)

    Posted

    Hello everyone,

     

    I am having trouble deciding between 1.5mm TM Armour and 2.0mm.  I have a full set of AP Armour, and I have an RS bucket.  The detail on the RS is fantastic, but I really like the rigidity of the 2.0mm AP Armour.  I just worry about sacrificing detail for strength.

    Can someone point me toward some pictures of 2.0mm TM Armour?  I've seen numerous TM build threads, but I can never tell if I'm looking at 1.5mm or 2.0mm pictures.

    Those of you with TM Armour; what was your reasoning for going one way or the other, and which way did you decide to go?

    Thanks a lot for any assistance or guidance on this. 

     

    Kevin

     

  7. ANH Thermal Detonator

    in Assembly, Mods, and Painting

    Posted

    I have a set of AP armor which I like very much, but I think the thermal detonator is a little small. The diameter is 2 3/8 inch. I think I read somewhere that the original parts were 68 mm.

    What is the overall length with the end caps in place?

    I have some 2 1/2 inch gray ABS tube from Plastruct, which is a lot closer to 68 mm than 2 3/8 inch. I plan to make a pattern to vacuum form new end caps. Just want to make sure I get the overall length right.

    Thanks for any input.

    Kevin

     

     

    Sent from my iPhone

×
×
  • Create New...