battery

job done, thanks for the suggestions- mislaid my screwdriver so lacking that i used two knives and a hammer bonus pic of idiot in armour

what is the general technique used in bending these bastards? everything i try feels like i'm about to shatter the entire codpiece!

just feels as if i am dramatically altering the left piece in the photo if i trim it until it matches with the right piece am i overthinking this? should i just start hacking away til it aligns?

Hey guys, completely new to building and have what might be a stupid question but i want to make sure before i go ahead and possibly mess something up- I'm about to glue my biceps and i want to make sure i'm doing it right, holding the two piece together produces this, am i supposed to just ignore that it doesn't match up much and just trim it once glued to make it line up? RS propmaster armour if anyone is wondering.

dropped Rob @ RS an email and he is sending a set of cover strips my way tomorrow, crisis averted! cheers Rob

don't appear to have, have just triple-checked everything i received and the only loose bits (minus gloves & sniper kneeplate) are pictured below, fairly sure none of that is a sheet of space plastic!

hey guys, i'm trimming my RS PM bicep pieces and i'm curious where the cover strip comes in to play, was i supposed to have received cover strips with the armour or am i supposed to source my own? I don't seem to have any and have looked at dozens of builds that all have them.