Sancho

okay found all kinds of stuff on glue here, but now I'm more confused I see people using super glue, epoxy, plastic bonds, ABS glue, and even hot glue. Since I have worked with epoxies before I think I will go that route, but I'm lost on the difference between an epoxy and plastic bond. I thought they were the same. Am I way off on that? If so which is better?

Okay one last question... can someone tell me what CA glue is?

A lot of great advice guys thanks! Only question just to make sure, if I glue both seams won't that leave a wide gap around my wrists? I mean the end would have to be big enough to put my hand through right since both seams are sealed. Do you have a pic of the front view of the forearms where the hand comes thorough?

I just started building my AP armor and started on the forearm pieces. I having a little difficulty putting them together. I have it all trimmed like I want, but it just seems like the top flares out too much over the bottom piece. When I squeeze it it fits like I want, but I'm not sure if it looks at all right. I attached a couple pics from the inside and the outside of the forearm. Really need some advice, but please be gentle it's my first build...

Just purchased my AP armor and super excited about it Anyway seen lots of great posts on assembly, just wandering if anyone with AP can tell me what grit sandpaper did they use for smoothing out the edges?

Thanks guys, this helped a bunch!

First off I'm really new So that being said I'm planning on buying some AP armor in the next week or so, only I have a question for all those who have AP armor. I'm 5'9" about 185lbs. I'm hoping that AP won't be too small in the chest area. Will I have to modify a bit? I'm scared to buy armor and find out there's no way I can squeeze into it