[Request your EIB Certificate here:]

Christine Harris

TK-61102

EIB

Letter

TKSpartan

 

Here you are, Christine!-  https://www.whitearmor.net/eib/certificates/61102-eib.png

 

 

 

[Request your Centurion Certificate here:]

Christine Harris

TK-61102

Centurion

Letter 

TKSpartan

 

Way to go, trooper!!      https://www.whitearmor.net/eib/certificates/61102-centurion.png

 

[TK-61102 requesting ANH TK Stunt Centurion status (Anovos) ( 517)]

Thank you!!! 

 

And a big thank you to the troopers who took the time to comment and offer support. 

 

 

 

[TK-61102 requesting ANH TK Stunt Centurion status (Anovos) ( 517)]

Hello!

I've completed the changes you requested.

 

Teeth: I used paint remover and pushed back the paint on the teeth.

Ear Screws: Replaced with flat slot-head screws. I needed to lift the glued s trim to change the screws. When I get the ok on them I'll glue the trim back down. 

Mic tips: Painted inside of mic tips entirely white.

Ab button plate: Removed, trimmed and re-glued rectangular ab button plate.

Forearm opening: Trimmed off remaining return edge from hand opening on both forearms.

Belt: Starched and Ironed belt. Re-took photos with belt on tighter. As you mentioned, I think it was just on a bit loose before.

Knee: Removed and re-glued sniper plate higher; now it follows the ridge line. 

 

 

 

 

 

 

 

 

 

[TK-61102 requesting ANH TK Stunt Centurion status (Anovos) ( 517)]

Thank you for the feedback and advice.

 

I've looked over the list of changes required and they all seem doable. I'm very busy with work right now so it may take a couple of weeks. 

Stay tuned! 

 

[TK-61102 requesting ANH TK Stunt Centurion status (Anovos) ( 517)]

I added the pictures from the correct checklist and an action photo.

[TK-61102 requesting ANH TK Stunt Centurion status (Anovos) ( 517)]

Oh. That also was not clear in what I was reading. I think the crl threw me off.   

 

Good news, I do have a blaster, the same one I applied for EIB with. I will add photos later today.  

 

 

[TK-61102 requesting ANH TK Stunt Centurion status (Anovos) ( 517)]

1 minute ago, TKSpartan said:

 

Thank you !,  just need the E11 Blaster photos and we're ready to start.  

I am applying without the blaster. 

[TK-61102 requesting ANH TK Stunt Centurion status (Anovos) ( 517)]

6 minutes ago, TKSpartan said:

 

Don't worry, we'll be here when you're ready. 

I think it should be all there now!   

[TK-61102 requesting ANH TK Stunt Centurion status (Anovos) ( 517)]

Ok!

Not a problem. Sorry about that. There's a couple checklists floating around this topic so I missed that specific one. 

I'll get to it asap.

Sorry again for the delay. 

[Need help deleting recent unposted attachments]

I found that tutorial from another post you replied to.  Thank you! 

 

 

[TK-61102 requesting ANH TK Stunt Centurion status (Anovos) ( 517)]

Name: Christine Harris 

Armour: Anovos 

Helmet: Anovos

Blaster: Resin Blaster

EIB thread:

https://www.whitearmor.net/forum/topic/36821-tk-61102-requesting-anh-stunt-eib-status-anovos570/

 

Height: 5’10”

Boots: TKboots

Canvas belt: Custom

Hand Plates: Silicon 

Electronics: N/A

Neck Seal: Custom 

Holster: Anovos

 

Hello, thank you for taking the time to consider my TK build for Centurion. 

 

I built this kit to Centurion level when I originally built it in 2016. Due to health issues and then the pandemic my application was delayed….I am FINALLY doing it!! I have read over the requirements and found a couple changes that have been added since 2016, which I went ahead and updated. 

-painted my mic tips outer edge white

-glued abs backing behind the lower thigh ridges and will be adding slurry next to cover.

 

Please note: My bucket S trim is glued so it can't be lifted easily for a photo. I posted a pic of the obvious extra ridge the S trim has but if you need a photo of the inside of the trim, let me know, I'll need to peel the glue. 

 

(above) my driveway is sloped a bit that's why I may look a tad crocked in the butt. 

 

 

 

 

 

 

 

 

 

 

 

[Need help deleting recent unposted attachments]

When someone gets to this, I'd just like all the attachments I added today (sept14th) removed. Thank you!!

[Need help deleting recent unposted attachments]

Hello, I attached photos to my Centurion request and blew over my size attachment allowance. 

Now I can't delete or edit them.

Help please!

 

 

[TK-61102 requesting ANH Stunt EIB status (Anovos)[570]]

Thank you!

[TK-61102 requesting ANH Stunt EIB status (Anovos)[570]]

Today I upgraded the metal mesh on my Hovi Tips. (I followed a tutorial posted my welshchris77, http://www.whitearmor.net/forum/topic/36456-Anovos-hovi-mic-tip-Mod).

 

I know it's not required for EIB but I noticed you guys were recommending it be done on other Anovos submissions.  

 

 

Here's a pic...

 

 

 

 

[TK-61102 requesting ANH Stunt EIB status (Anovos)[570]]

suuuuuuure!

 

 

[TK-61102 requesting ANH Stunt EIB status (Anovos)[570]]

Thanks Sly11. The pin is totally backwards! I noticed that too and I considered changing it. Although, it's a Resin blaster, I don't want to damage it trying to crack it out. I'll look into it again tho. Thanks again!

[TK-61102 requesting ANH Stunt EIB status (Anovos)[570]]

Christine Harris

TK-61102

FISD: Cupcake

Canadian Garrison
 
Armour: Anovos

Helmet: Anovos

Blaster: Resin
 
Height: 5'10"
Weight: 155lb
Boots: TK Boots
Canvas Belt: Anovos (Heavily modified and reinforced)
Handplates: Anovos
Neck Seal: Custom 
Holster: Altered Anovos
 
PHOTOS:

 

 

 

Thank you for your consideration!

 

Christine Harris

TK-61102

[501st Trooper Status Requests (Include link to your 501st profile in your request!)]

TK-61102 requesting access. 

http://www.501st.com/members/displaymember.php?userID=20284&costumeID=124