Jump to content

TK-28823 Requesting ANH (Stunt) EIB Status - (TM) (1053)


Recommended Posts

TK-28823 Requesting ANH (Stunt) EIB Status -Troopermaster

 

Trooper Info


Costume Information

  • Armor Maker: Troopermaster
  • Helmet Maker: Troopermaster
  • Neck seal: East Asia Supply
  • Belt: Troopermaster
  • Holster: Troopermaster
  • Boots: Imperial Boots
  • E-11 Blaster: TrooperBay rubber cast 

 

 

 

 

 

 

IMG_7673.jpg

IMG_7687.jpg

IMG_7679.jpg

IMG_7684.jpg

IMG_7686.jpg

IMG_7692.jpg

Edited by Galton
Link to comment
Share on other sites

Hi Galton, and THANKS for your submission for ANH Stunt Expert Infantry!  That is an awesome looking set of armor there, sir, but unfortunately there is an issue you need to correct before we can get started.

 

The control panel (raised rectangle) on your TD is similar to those used in ROTJ and will need to be changed to the ANH version.

 

I know your armor is TM and they certainly make an ROTJ version of the TD plate, but I have never seen the particular one you are using.  It's kind of odd that the round "washer" at the top is correct for ANH, but not the rectangular area.  

 

                                  Yours                                                                          ROTJ (screen used)                                                                TM ROTJ TD plate

    E6SvHPB.jpg           UvnswJu.jpg       4cOujRx.jpg

 

                      ANH screen used                                                                  TM ANH TD plate

 ucOVMXY.jpg  Z1zkO3v.jpg

 

Also, please post up some detail pics of your bucket as seen below-

 

 

    lHxkm1E.jpg?1    u2rEt2u.jpg?1     fxW54p1.jpg?1

 

As soon as you get this sorted please post up some new photos:  Suited up (rear shot) and a close up of the new plate so that we can move ahead and get that EI badge under your name.  Thanks!!   :salute:

  • Like 2
Link to comment
Share on other sites

18 hours ago, justjoseph63 said:

Hi Galton, and THANKS for your submission for ANH Stunt Expert Infantry!  That is an awesome looking set of armor there, sir, but unfortunately there is an issue you need to correct before we can get started.

 

The control panel (raised rectangle) on your TD is similar to those used in ROTJ and will need to be changed to the ANH version.

 

I know your armor is TM and they certainly make an ROTJ version of the TD plate, but I have never seen the particular one you are using.  It's kind of odd that the round "washer" at the top is correct for ANH, but not the rectangular area.  

 

                                  Yours                                                                          ROTJ (screen used)                                                                TM ROTJ TD plate

    E6SvHPB.jpg           UvnswJu.jpg       4cOujRx.jpg

 

                      ANH screen used                                                                  TM ANH TD plate

 ucOVMXY.jpg  Z1zkO3v.jpg

 

Also, please post up some detail pics of your bucket as seen below-

 

 

    lHxkm1E.jpg?1    u2rEt2u.jpg?1     fxW54p1.jpg?1

 

As soon as you get this sorted please post up some new photos:  Suited up (rear shot) and a close up of the new plate so that we can move ahead and get that EI badge under your name.  Thanks!!   :salute:


Hi Joseph, Thanks very much your comment, I will upload helmet photo first, thermal detonator will be upload latter.:)

 

IMG_7106.1.jpg.f298c0f8cc0572a08cf9cbd4380e5319.jpg

IMG_7108.1.jpg

IMG_7109.1.jpg

IMG_7107.1.jpg

Edited by Galton
  • Like 1
Link to comment
Share on other sites

7 minutes ago, Galton said:

THERMAL DETONATOR:

I obtained a surplus detonator from a HKG teammate to replace the ROTJ one today.
 

 


signal-2022-10-21-150351.jpg.cb9590e0e6f559fde92286ba2a78bea4.jpgsignal-2022-10-21-150348.jpg.4f21dc41df914a91f6962d78afd5e3af.jpg

 

Wow that was fast! Troopers helping troopers indeed! :salute:::dancing-trooper:

  • Like 1
Link to comment
Share on other sites

Hello Galton. Thank you for your application. In order to proceed, we will need a photo of this part: 
-Cod and posterior plate connections showing rivet/snaps (exterior/interior).

 

Something like this:

 

Ext.                                          Int.

v2qw0HE.jpg      Tj0qbty.png

 

Thanks!:salute:

  • Like 1
Link to comment
Share on other sites

 

6 hours ago, Chemi said:

Hello Galton. Thank you for your application. In order to proceed, we will need a photo of this part: 
-Cod and posterior plate connections showing rivet/snaps (exterior/interior).

 

Something like this:

 

Ext.                                          Int.

v2qw0HE.jpg      Tj0qbty.png

 

Thanks!:salute:

 

 

 

Hi Chem, Thanks for your review, i am sorry about forgot upload photo the part of plate connections.

 

 

image.thumb.jpeg.561cf315748398c0546ed34a076209f8.jpeg

 

On 10/20/2022 at 11:34 PM, jsilvius said:

 

 

 

Link to comment
Share on other sites

14 hours ago, Chemi said:

Hello Galton. Thank you for your application. In order to proceed, we will need a photo of this part: 
-Cod and posterior plate connections showing rivet/snaps (exterior/interior).

 

Something like this:

 

Ext.                                          Int.

v2qw0HE.jpg      Tj0qbty.png

 

Thanks!:salute:

 

Hi Chemi,

 

I am sorry the late photo.
 

IMG_7140.1.jpg

Edited by Galton
  • Like 2
Link to comment
Share on other sites

Hi Galton, and THANKS for your submission for ANH Stunt EI!

 

CRL and EIB Application Requirements:

All required photos have been submitted, and on behalf of the entire D.O. staff we are pleased to welcome you to the rank of Expert Infantry.  Congratulations!  :salute:

 

Other-Armor Fit/Assembly;

In this area we review observations made by your fellow troopers and the DO team.  Some observations may lead to suggestions to improve the overall look of your armor, and please keep in mind that  we consider both text (CRL) and pictures (screen caps/reference images) when reviewing submissions.

 

Congratulations Galton. You have a great looking suit of armor. We're just going to add a few things that will make it definitely PERFECT.:duim:

 

Let's start with the helmet.

 

- This is a very common issue.;). The screws on the ears should ideally align with the rear angle of the trap above them, and the bottom should angle back a little bit more. 

The right ear could be improved a little. The left ear is perfect:jc_doublethumbup:.

 

                                                                                                                                                                         Reference images

cwUiPla.jpg   9bJdzKw.jpg                    qdZeHpP.jpg   8xlWFlJ.jpg   wcYujEl.jpg

 

 

-Your helmet seems to be riding a little high. Maybe you have too much padding on the top. You could remove a little of that padding. so the helmet will lower a little.

 

                                                                                                                                                                                                                         Reference images

uz2qPEg.jpg   S3gA7j0.jpg        lWN15kU.png    tZUuh7f.png

 

 

- You could try to get a better arch in your straps with a hot water bath....Doing this would allow them to ride closer to the back plate so they won't protrude out, and put less strain on the elastic strap. You will also prevent them from getting caught on something and breaking.:jc_doublethumbup:

 

                                                                                                                                               Reference images

114zjVH.jpg                    I580cCf.jpg   ACTwld3.jpg   MJuOFKd.jpg

 

 

-One small dressing issue here. The right forearm is a little high than the left. It's very little, but if you lower it you'll avoid the bite in the back.:laugh1:

 

Front                                                                            Back                                                                                     Reference image

Qznih4f.jpg   MbxoGmR.jpg                 n938OSK.png   

 

 

-Ideally the screws of the TD should sit closer to the ends of the clips.

 

                                                                                                                                              Reference images  

ZVAXvN8.jpg                          qx7NEjw.png   PNEgG5u.png   5LuR0Le.png   

 

 

-For a better look, we recommend trimming the edge on both sides of the sniper knee, so that it is aligned with the "bottom edge" and looks more screen-accurate. Very easy fix!!!:)

 

                                                                                                                                                                     Reference images

J7DJuat.jpg   xNox3lg.jpg             MZFx9IW.png   p9BwNIo.png   

 

 

-Also, some  strap, Velcro or similar is sticking out :icon_eek:. You can cut it or bend it inward so that it is not visible.;)

 

                                                                                                                                                                  Reference images

y2p2HVs.jpg                      URvtFzv.png  MZFx9IW.png   p9BwNIo.png   

 

 

 

 

 

Centurion Requirements:

In this section we prepare you for our highest tier of approval.  Because Centurion photos must show more detail than EIB, items pertaining to Level 3 might be seen there and not here and additional photos may be required. We try to point out all that we can from what we are able to clearly see, but the final accuracy is the responsibility of the trooper.

 

 

-L3. Abdominal and Kidney Plate align horizontally at top.  In another photo (you can see it in the next point), the position was correct. You may just need to tighten the straps a bit to prevent it from moving. :jc_doublethumbup:.

 

                                                                                                                                Reference images

kHCj2Sr.jpg                        ICtQbll.png   4Le4CZc.png

 

 

-L3. Ideally there no gap between the abdomen and kidney armor. The gap is minimal. Just tighten the belt a little bit and you're done :peace:

 

                                                                                                                                                                                                            Reference images

JzmALI0.jpg    Gl7aBjA.jpg            JQtAzbi.png     ICtQbll.png

 

 

-L3. The top of the ABS ammo belt should sit at or just above the bottom of the central and vertical abdomen button panels. Many people put some Velcro on the rear of the belt to prevent it from moving down. ;)

 

                                                                                                                                                                      Reference images

lOUJIZ8.jpg                xBdwWlP.jpg     Q2X9NlL.jpg   

 

 

- L3. T-tracks and grips shall be of a black plastic appearance with no silver/metallic weathering allowed. There appears to be some weathering on the grip. A coat of black paint and it' s done.

 

                                                                                                                                                  Reference images

ytfIugO.jpg   j3PVQgE.jpg                   PIgrHnk.jpg    qfDCdfP.jpg

 

 

 

 

And that's all Galton. A few minor easy fixes and your armor will be ready for the Centurion request. :th_AnimatedBravoSmiley:

 

 

You can request your EIB Certificate HERE

 

 

  • Like 1
Link to comment
Share on other sites

  • Chemi changed the title to TK-28823 Requesting ANH (Stunt) EIB Status - [Troopermaster] (1053)

Dear Chemi, I am very gratefully the DO team approval my EIB requesting and suggested fixes for upgrade to the centurion requirements tips, thanks again :salute:

  • Like 2
Link to comment
Share on other sites

Congratulations trooper and welcome to the EI ranks and Expert Infantry Honor gallery

 

id0ufbv.png

  • Like 1
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...