Jump to content

Kmac ANH Stunt ATA


KMAC
 Share

Recommended Posts

Hi all from NZ,

 

I have started on my first build, ATA Armour,  and have been working on Bucket, just need some advice on the dreaded ears.  I am at a stage where I have got them as good as I can get but was after advice if the sides where screws are at top are too thick? I was going to take them back a bit but didn't really want to if they are ok.

Thanks in advance 

 

ytXsNsY.jpg?1oC94Wf5.jpg?10P4Uorf.jpg?1

Link to comment
Share on other sites

8 hours ago, KMAC said:

I was going to take them back a bit but didn't really want to if they are ok.

I don’t think you’ll have a problem getting approved:duim: With that said, givning them a light shave wouldn’t go a miss as the movie-ears usually were a bit thinner - choice is yours:salute: (might have to zoom a bit to see though:P)

K0DYMkv.jpg

  • Like 1
Link to comment
Share on other sites

Slow and steady, just minor adjustments at a time ;) 

 

If you are aiming for higher levels you can compare with this ATA EIB review as the ear thickness was mentioned

 

Also adding a step to the top portion of the ear will allow the ear to sit flush, this thread I mentioned earlier has a step by step method

027.jpg

 

Looking forward to seeing your progress, good luck

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

×
×
  • Create New...