funkster[TK] Posted October 14, 2022 Author Report Share Posted October 14, 2022 Calves Quote Link to comment Share on other sites More sharing options...
funkster[TK] Posted October 14, 2022 Author Report Share Posted October 14, 2022 Chest / Back Quote Link to comment Share on other sites More sharing options...
funkster[TK] Posted October 14, 2022 Author Report Share Posted October 14, 2022 Blaster (After the pics, was pointed out I’d put the side detail decal in the wrong place)Just gotta add a d-ring Quote Link to comment Share on other sites More sharing options...
funkster[TK] Posted October 14, 2022 Author Report Share Posted October 14, 2022 Quick bit of test fitting 1 Quote Link to comment Share on other sites More sharing options...
TKSpartan[Staff] Posted October 14, 2022 Report Share Posted October 14, 2022 Everything looks awesome!!! Quote Link to comment Share on other sites More sharing options...
gmrhodes13[Staff] Posted October 14, 2022 Report Share Posted October 14, 2022 Very nice so far. One thing you could update is the detonator, TLJ actually had a sperate tube and the upper black slot and control panel were cut out showing the tube behind Quote Link to comment Share on other sites More sharing options...
funkster[TK] Posted October 14, 2022 Author Report Share Posted October 14, 2022 Yeah the designer I believe has updated the file for that. If I’m brutally honest, this build has been dragging on for 3 years now and I just wanna get it done 2 Quote Link to comment Share on other sites More sharing options...
funkster[TK] Posted October 15, 2022 Author Report Share Posted October 15, 2022 Forearms all done TFA shape, but separate box and screw added 1 Quote Link to comment Share on other sites More sharing options...
funkster[TK] Posted October 16, 2022 Author Report Share Posted October 16, 2022 Modified BS lidI added the rear groove by cutting a 1.5 piece of styrene at the height needed from the black section. Stuck that on with double sided tape. Then VERY CAREFULLY went round with a needle file and kept going until the desired depth After painting I added black vinyl in the recess running round the bottom Pauldron from Trooper Bay with added vinyl 2 Quote Link to comment Share on other sites More sharing options...
funkster[TK] Posted October 17, 2022 Author Report Share Posted October 17, 2022 Other than the lid and pauldron, all 3d printed on my CR-10s 3 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.