Jump to content

TK-11672 Requesting ANH Stunt EIB Status (SDS) [952]


Sidius

Recommended Posts

Name: Carsten Hüne
501st Legion TK ID: 11672
FISD Forum Name: Sidius
Garrison: German Garrison / Echo Nova Squad
Armor: Shepperton Design Studios (SDS) Battle Spec
Helmet: Shepperton Design Studios (SDS) Battle Spec
Blaster: E11 (Droopydoo's + Upgrades)
Height: 5'10"
Weight: 253 lbs (at the time of the photo ;))

Boots: unknown

Canvas belt: made by "felice" [TK-20047] (German Garrison)
Hand Plates: Latex on Rubber Gloves
Electronics: TRamp Voice Amplifier
Neck Seal: 16 rib / made by "Girls Got Fabric" (Facebook)
Holster: TrooperNRW (German Garrison)

 

20191007-161838.jpg

 

20191007-161754.jpg

 

20191007-161722.jpg

 

20191007-161650.jpg

 

20170430-100701.jpg

 

20191009-210000.jpg

 

Carsten-H-ne-vorne.jpgCarsten-H-ne-hinten.jpg

 

Carsten-H-ne-rechts.jpgCarsten-H-ne-links.jpg

 

20191124-190505.jpg20191124-190329.jpg

 

Carsten-H-ne-ohne-Helm.jpgCarsten-H-ne-authentisch.jpg

 

20191009-210426.jpg

 

20191009-205814.jpg

 

 

20191125-180731.jpg20191125-181059.jpg

 

20170830-131355.jpg

 

20170830-131331.jpg

 

20170323-162650.jpg

 

Thanks in advance!

 

Greetings from Berlin, Germany

Edited by Sidius
Link to comment
Share on other sites

Nice work, Carsten, and thanks for your submission!  Before we can move forward, we can you add a close-up photo of the cod and posterior tab showing the rivet and snaps (exterior view) as well as a close-up of the tops of your boots?  Thanks!!!

 

            Example

wmUQv99.jpg

 

 

 

Link to comment
Share on other sites

Nice work trooper, a couple of other pics the DO's like are:

* Front and both sides of the knee sniper plate

* Thigh ammo strip rivets outside and inside 

* TD showing front panel 

* D ring on rear of blaster 

* Close up of ab rivets

 

A few things you may want to address while waiting for the DO's:

With your teeth area you could remove some paint from the gums: Frown is painted gray and does not leave the teeth area.

 

You could also straighten the brow trim, it appears higher in the centre

 

20191007-161838.jpg Image result for frown whitearmor"

 

 

Appears your left shin is closing inside over outside so the opening can be seen from the outside, they should close outside over inside

Carsten-H-ne-links.jpgCarsten-H-ne-hinten.jpg

 

You may want to lengthen the drop box straps, they appear tight and push outwards. Also thigh coverstrips should stop above the bottom thigh ridge 

Carsten-H-ne-vorne.jpgTK_anh_stunt_thighs.jpeg

Belt could come down a little too as it's covering the lower button 

Carsten-H-ne-ohne-Helm.jpg

 

A few tweaks and I'm sure you'll do fine, good luck 

  •  
  •  

 

 

 
 

 

  • Like 3
Link to comment
Share on other sites

Carsten, 

 

Along with the paint on the frown or teeth area that gmrhodes13 pointed out the rear left calf will have to be fixed prior to going any further, as this is a requirement for Basic.

The cover strip edge shall be facing the inside of the leg.

2jimRID.jpg     WARrUDO.jpg?1

  • Like 1
Link to comment
Share on other sites

Hi,

none of this should be such a big problem - of course i'll do it all! :salute:

But that could take a few days since I'm currently on vacation...

 
  • Like 1
Link to comment
Share on other sites

4 hours ago, Sidius said:

none of this should be such a big problem - of course i'll do it all! :salute:

Now that's what we like to hear, Carsten!  :duim:

  • Like 1
Link to comment
Share on other sites

So, the vacation is over and the next batch of photos is coming! :D

 

First the newly glued calves (closed outside over inside):

 

20200106-161044.jpg

 

Front and both sides of the knee sniper plate:

 

20200106-161115.jpg

 

20200106-161105.jpg

 

20200106-161142.jpg

 

Different views (front panel) of the TD:

 

20200106-161256.jpg

 

20200106-161310.jpg

 

20200106-161319.jpg

 

Close ups of the abdomen rivets:

 

20200106-161436.jpg

 

20200106-161518.jpg

 

The rest will follow soon...

Edited by Sidius
  • Like 1
Link to comment
Share on other sites

Ok, here comes the next run of photos...

 

Now the thight coverstripes stops above the button thigh ridge:

20200111-163044.jpg

 

Thigh ammo strip rivets outside and inside (both sides):

20200111-164147.jpg

 

20200111-164303.jpg

 

Now only the photos of the helmet are missing, right?

Link to comment
Share on other sites

19 hours ago, Sidius said:

And now, here comes the helmet...

 

- Now the grey painted frown does not leave the teeth area.

 

- the brow is straighten now

 

20200112-193107.jpg

Funny what little changes make....... We’ll have you at EIB in no time! 

  • Like 1
Link to comment
Share on other sites

20 hours ago, msouza said:

Funny what little changes make....... We’ll have you at EIB in no time! 

Thank you very much - I'd be really happy about that! 
Is there anything missing now? 
  • Like 2
Link to comment
Share on other sites

  • 2 weeks later...

Hi Carsten,


Thanks for your application for EIB and helping us continue towards our goal of 1000 EIB Troopers ! 

 

CRL and EIB Application Requirements

All required photos are now in and, after review, we are pleased to welcome you to Expert Infantry rank. On behalf of the DO team and myself, many congratulations! :duim: 

 

Other-Armor Fit/Assembly

In this area we review observations made by your fellow troopers and the DO team. Some observations may lead to suggestions to improve the overall look of your armor. Note that we consider both text (CRL) and pictures (screen caps/reference images) when reviewing submissions

 

With all apps we like to start from the top down, lets get started. 

 

First off I want to say great job on making the suggested changes, your "I got this" attitude really paid off. The only suggestion I could make would be your ear placement. Honestly this is one of the most overlooked parts of a build. Most are concerned with the fit and trying to get the gap to a minimum and tend to line the ear up with the seam to cover the rivets but you'll notice that the should be in line with the template traps. 

 

                                                                                           Reference Photos

 QnBLyUsm.jpg    fhwgymnm.jpg    aqL1Zj9.jpg?2&key=37f55a72d1153b80869560   wAMSyBP.jpg?2

 

Next we'll move down to your shoulders. 

 

I'd like to see you try to get the tops of your bells touching your shoulder straps. 

I would start by trimming the return edge and tighten up the top strap a bit, that should get them to sit better.  

                                                                                                                                                                              Reference Photo 

iQuIVT5m.jpg   XWLfqLDm.jpg    PKo3cnUm.jpg

 

Next would be you belt boxes, 

Looks as if a bit of E-6000 is needed. Take a the first photo and you'll see how it hangs exactly as it should but then you'll also see how it tends to shift a bit. A little dab of E 6000 would have that staying perfectly aligned. 

 

                                                                                                        Reference Photo

frpaBPA.jpg?1&key=b88f8f4078e205874e5f98  KDSm1yD.jpg&key=e084d865da709f2b66ae6cc4    kqU2veZm.jpg

 

 

 

Centurion Requirements

In this section we prepare you for Centurion. More photos may be requested in the future that allow us to make better decisions on possible adjustments. If there are any areas of concern they will be discussed here.


Because Centurion photos show much more detail than EIB, items to pertaining to Centurion might be seen there and not here. We try to point out all that we can from what is seen, but the final accuracy is the responsibility of the trooper. 

 

Just like before we'll start from the top down. 

 

First up on your helmet is your Vocoder.

Unfortunately, since the vocoder on your helmet is a separate piece and not molded into the helmet itself it cannot pass at Centurion level.  Although not yet added to the CRL, this issue was voted on and approved last November.  Here is the link:   https://www.whitearmor.net/forum/topic/48294-proposed-amendment-to-ot-anhesbrotjhwt-etc-crls-helmetvocoder-detail/

Separate vocoder          Reference Photo

pymY2Dw.jpg   YJgx0NV.jpg?1

 

 

Onto your shoulder bells 

I think once you trim away the return edge on the bells this will help alot. 

There should be a minimal gap between the shoulder armor and the chest/back plates.

                                                                                  Reference Photos 

eQHSxwLm.jpg       6lIFhSYm.jpg    5GKZpcy.jpg?1&key=0f9b4282be54eed22aa29d

 

 

Onto your Ab buttons 

  • Ab button paint shall not extend beyond the bottom of the actual raised button.
  • No separate buttons are allowed.

C05ILOw.jpg     vzH3JEv.jpg

 

 

And the last thing on the list to touch on would be your kidney plate to ab. 

This should be an easy fix as it looks like you might need to do some more filling and a little repainting will do the trick. 

Ideally there no gap between the abdomen and kidney armor. Abdominal and Kidney Plate align horizontally at top.

  • A single visible seam line is present.

 

u5N9vMIm.jpg  mJfaMkJ.jpg      spj4f0C.jpg

 

 

You've done an amazing job with the fix's you've made so far and I have no doubt that you can do it again to reach Centurion. 

Congratulations Trooper and welcome to EIB!  

  • Like 1
Link to comment
Share on other sites

Hey Mike,

 

many thanks to you and to the entire team for processing my request and for inclusion in the ranks of the EIB! :salute:

I'm really happy!!! :dancing-trooper:

You wrote that there are not quite 1000 EIBs yet - what number am I now?

 

In order to improve the overall impression of my costume, I'll continue to work on it ... however, I still have a few other projects ahead of me, that I've to work on first. :duim:

Link to comment
Share on other sites

Congratulations trooper.

 

Welcome to the ranks.

 

From what I saw you should be #952, but let’s just wait for the DO to make a confirmation.

  • Like 1
Link to comment
Share on other sites

  • TheSwede changed the title to TK-22672 Requesting ANH Stunt EIB Status [952]

Hi mates!

 

First of all, many thanks to all the well-wishers - I'm really happy to be a part of the troops! :smiley-sw013:

 

And then thank you for editing the headline of my topic with the my EIB-No. [952]... :duim:

...but unfortunatly a small mistake seems to have crept in: My TK-Number!

Now it says "TK-22672" in the topic headline, but mine is "TK-11672"...

Maybe that would have to be changed again - not that there is still a mix-up! ;)

Edited by Sidius
Link to comment
Share on other sites

  • shashachu changed the title to TK-12672 Requesting ANH Stunt EIB Status [952]

@shashachu First of all, thank you for your answer! :smiley-sw013:

I'm really sorry, but only there's been another little mistake... :unsure:

My TKID is 11672...not 12672.

Soooorry for the inconvenience... :blush:

 

Link to comment
Share on other sites

3 hours ago, Sidius said:

@shashachu First of all, thank you for your answer! :smiley-sw013:

I'm really sorry, but only there's been another little mistake... :unsure:

My TKID is 11672...not 12672.

Soooorry for the inconvenience... :blush:

 

Edited for you

  • Like 2
Link to comment
Share on other sites

  • justjoseph63 changed the title to TK-11672 Requesting ANH Stunt EIB Status (SDS) [952]

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...