Darth_Walker Posted October 7, 2019 Report Share Posted October 7, 2019 (edited) Hey guys, this is my first post here. I have a question about the spacing between the armour pieces. I have attached some pictures of where i am at. I have a 3mm gap because of the flat head screws. Is this an acceptable gap for centurion or should i drill out some more of the armour to try and countersink the screws. Thanks in Advance, and i am loving this forum, so much info and pictures. Wonderful community James Edited January 10, 2022 by gmrhodes13 photo updated Quote Link to comment Share on other sites More sharing options...
Rat[TK] Posted October 7, 2019 Report Share Posted October 7, 2019 Put simply it states in the CRL minimal gap. I think this should be acceptable, but I'm no D.O., Deployment Officer. I'm centurion approved and I'm sure I have at least that amount of gap. Sent from my 5054N using Tapatalk Quote Link to comment Share on other sites More sharing options...
Sly11[Admin] Posted October 7, 2019 Report Share Posted October 7, 2019 You wont have any issue with that. I'll also add that your belt sit across that gap so it would never be seen anyway. 1 Quote Link to comment Share on other sites More sharing options...
TKSpartan[Staff] Posted October 7, 2019 Report Share Posted October 7, 2019 No problem. Quote Link to comment Share on other sites More sharing options...
Darth_Walker Posted October 8, 2019 Author Report Share Posted October 8, 2019 Fantastic, Thanks for the replies Quote Link to comment Share on other sites More sharing options...
TheSwede[TK] Posted October 8, 2019 Report Share Posted October 8, 2019 On 10/7/2019 at 8:07 AM, Darth_Walker said: I have a question about the spacing between the armour pieces You are good to go Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.