Kevin Schnable Posted June 26, 2019 Report Share Posted June 26, 2019 Can anyone help me out? I’m having an issue gluing my thigh pieces together. I’m using E6000 glue but its not holding up once i try to assemble the other side. It keeps pulling the glue off the other strip. Any alternative ways to assemble them. HELP!!! Quote Link to comment Share on other sites More sharing options...
TheSwede[TK] Posted June 26, 2019 Report Share Posted June 26, 2019 15 minutes ago, Kevin Schnable said: Can anyone help me out? I’m having an issue gluing my thigh pieces together. I’m using E6000 glue but its not holding up once i try to assemble the other side. It keeps pulling the glue off the other strip. Any alternative ways to assemble them. HELP!!! Hey Kevin Have you let the glue have enough time to set properly, 24-48h? Quote Link to comment Share on other sites More sharing options...
gmrhodes13[Staff] Posted June 26, 2019 Report Share Posted June 26, 2019 Are you gluing one side at a time and letting that side dry? E6000 can take up to 72 hours to dry fully, I normally leave for 24 hours. Also using a combination of clamps, magnets and painters tape can help Quote Link to comment Share on other sites More sharing options...
Kevin Schnable Posted June 26, 2019 Author Report Share Posted June 26, 2019 I did glue one side of the strip at a time ..... I may need to get stronger magnets... Any suggestions on a particular strong magnet? Also should i duct tape the insides while i glue the strips? Quote Link to comment Share on other sites More sharing options...
gmrhodes13[Staff] Posted June 26, 2019 Report Share Posted June 26, 2019 Rare earth magnets can be found on eBay, i use 20mm x 3mm and 15mm x 5mm, I have about 200 of them I've collected over the years but a good cheap substitute is painters tape, you can wrap around the thigh and use some pressure while doing it and it will hold them tight, may need to go around a couple of times. I just used painters tape on the insides too to keep them together while applying the cover strip, duct tape may be a bit of overkill and leave some glue residue. Make sure you leave for at least 24hours to dry in between adding strips. Quote Link to comment Share on other sites More sharing options...
Kevin Schnable Posted June 26, 2019 Author Report Share Posted June 26, 2019 Thanks for the info 1 Quote Link to comment Share on other sites More sharing options...
TKSpartan[Staff] Posted June 26, 2019 Report Share Posted June 26, 2019 I remember I used clamps for the ends and magnets in the middle , you could try adding them too . but definitely , the drying time is so important. good luck Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.