DirectorEdward Posted December 16, 2018 Report Share Posted December 16, 2018 Hello, my name is Edward from Garrison Tyranus. I’m doing a Deathtrooper build and I had some general fitting questions. Is there a guide on how each piece should fit? I have 3D printed parts from Armor Shop and they are incredibly strong and well-made. But I can’t quite figure out how to attach the shoulder bells without them flopping either to the rear or the front. Any tips? Also, what is a “return edge”? Respectfully, Edward Legion ID 60086 Quote Link to comment Share on other sites More sharing options...
gmrhodes13[Staff] Posted December 16, 2018 Report Share Posted December 16, 2018 (edited) Hello and welcome to the forums. Return Edge - Lip normally found on moulded parts Strapping - general layout Arm strapping Hope those help BTW if you are an approved 501st member you can request higher access here https://www.whitearmor.net/forum/topic/16-501st-trooper-status-requests-include-link-to-your-501st-profile-in-your-request/?page=264&tab=comments#comment-636191 Edited December 15, 2020 by gmrhodes13 link not working, removed gmrhodes13 2020 Quote Link to comment Share on other sites More sharing options...
tarok[TK] Posted December 17, 2018 Report Share Posted December 17, 2018 G’day EdwardThat’s the Rogue One Death Trooper? The folks over at the SpecOps Detachment might be well placed to assist with your strapping and build questions they specialise in that costume, amongst others.https://specops501st.com/HTHRudiSent from my DH77 using Tapatalk Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.