Peepants130[TK] Posted October 7, 2018 Report Share Posted October 7, 2018 Somewhere on a troop, the muzzle piece on my blaster went missing. It is a open barrel ANH E11. Can someone point me in a good direction for a replacement? Quote Link to comment Share on other sites More sharing options...
Rat[TK] Posted October 7, 2018 Report Share Posted October 7, 2018 Who makes it? That will help for sources for replacing.Sent from my VK815 using Tapatalk Quote Link to comment Share on other sites More sharing options...
justjoseph63[Staff] Posted October 7, 2018 Report Share Posted October 7, 2018 (edited) There are 2 alternatives you can use, Michael, resin or aluminum. Here is a seller on eBay that sells the resin ones: ----------- Below is a seller I used on my last Doopydoos build to replace the muzzle. I personally like the sharpness of the aluminum edges. I cut off the front and had to use a Dremel to thin out the barrel opening so that it would fit, but after some epoxy, sanding and painting it came out great. ----------- I also used his aluminum parts to replace the mag well, folding stock, magazine and end cap. Edited September 15, 2022 by gmrhodes13 link removed no longer working 2 Quote Link to comment Share on other sites More sharing options...
darthcue[TK] Posted October 7, 2018 Report Share Posted October 7, 2018 I believe the one from ebay is not resin but solid plastic?Sent from my iPhone using Tapatalk Quote Link to comment Share on other sites More sharing options...
Harbinger[IPM] Posted October 8, 2018 Report Share Posted October 8, 2018 Resin/plastic should not matter all that much as long as the sizes are close IMO. Quote Link to comment Share on other sites More sharing options...
justjoseph63[Staff] Posted October 8, 2018 Report Share Posted October 8, 2018 19 hours ago, darthcue said: I believe the one from ebay is not resin but solid plastic? Sent from my iPhone using Tapatalk Like Brien mentioned, resin and plastic are both fairly easy to trim. Resin can be more brittle, though, and easier to chip. 1 Quote Link to comment Share on other sites More sharing options...
gmrhodes13[Staff] Posted October 8, 2018 Report Share Posted October 8, 2018 If you know someone with a 3d printer you could have one made. 1 Quote Link to comment Share on other sites More sharing options...
Truimphmark[TK] Posted October 9, 2018 Report Share Posted October 9, 2018 Think I may have one spare I’ll have a look and it be the cost of postage from uk to where ever you are I’ll look Sent from my iPad using Tapatalk Quote Link to comment Share on other sites More sharing options...
Peepants130[TK] Posted January 2, 2019 Author Report Share Posted January 2, 2019 Sorry guys, I haven't been ignoring you but eh, holidays. It is a RS Props model, aluminum barrel type. Thanks for the suggestions. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.