Jump to content

TK-89135 Requesting ANH Stunt EIB Status (RWA) [792]


Recommended Posts

Name: Simon Dawson
 
501st TK ID: 89135
 
FISD Name: Benny22
 
Garrison: UK Garrison
 
Profile Page: http://www.501st.com/members/displaymemberdetails.php?userID=26455
 
Armour Maker: RWA
 
Helmet Maker: RWA
 
Blaster: ShearTech
 
 
 
Height: 175 cm approx
 
Weight: 55 kg
 
Boots: Imperial Supply Depot
 
Canvas Belt: RWA
 
Hand plates/gloves: Imperial Supply Depot, Latex
 
Electronics: Aker amp, Troopacoola
 
Neck Seal: RWA
 
Holster: Imperial Supply Depot
 
 
Link to Armour WIP: http://www.ukgarrison.co.uk/forum/viewtopic.php?f=126&t=66136
 
 
Link to blaster build: http://www.ukgarrison.co.uk/forum/viewtopic.php?f=139&t=676253c4252f4d2c87c0b82e5aa726742554f.jpg509f0afc09d2e494b9c4290abdd0eb1c.jpg20338423b4602fc6d5047166b74ab37c.jpg630f536ee9ced196544a64f049b234b7.jpgc37fe10f89b0ade3bf6ee670b225b365.jpg41465e68e22e9b4d1071d6153310d82a.jpg1c2a16ca0f2ab9622b33e694b83493ce.jpgdd205fb9d500669c967c4c9a9bc43d9f.jpg612a4c47bd8e64bc8ee699259800a678.jpg55bd717faa8ff262b4cb22926fcfc5c7.jpg25e419c2eb76542192271e4b0765bdb2.jpg0968766d48911d9d5ddd16da935b2933.jpgf6e4fdb427202bb7bd300a7a33efe6c4.jpg0525d296ce877acf8b315b2e4ebcfa62.jpg9029e5122f1cca59f8ed36d97bade880.jpg4382bbe00a6ca780c2a5d87bc45196e3.jpg5a2986e0b4f40f868ebd2e4a5c989d13.jpg07cc54b552d6881fdc01dcc0a9bd501c.jpgd9776795993070824200fecc4e9617fd.jpg31fd503774197a5ba7ad0bf3b5ca562f.jpg207e0f2f2f9c9cd2bf27eb9865343655.jpgb7356493c53774265fb73c78cf4e0257.jpgaa4b50f455d8471bb8c00e0b43cd3937.jpg97171e1f9d7b1100dff020552a835f89.jpg190ec1791a1332781135354d25f5391c.jpg06c0f76f6a15504a22870deb3de53a75.jpgae2ea7fb825b659e2a85824b081e5710.jpg1be4bf037492bc44b5b2bdfccb918f3b.jpg
 
 
 


3aac879a91c6d398e1d36906e7f6a9bd.jpgab4766b027a3f01d1cb82cc132353190.jpg

  • Like 2
Link to comment
Share on other sites

Looks good.

My only watch outs would be your cover strips on your biceps go beyond the biceps. I would make sure they sit flush with the armor.

 

Good Luck Bud.

Should be a quick approval.

Link to comment
Share on other sites

Looks good.
My only watch outs would be your cover strips on your biceps go beyond the biceps. I would make sure they sit flush with the armor.
 
Good Luck Bud.
Should be a quick approval.
Good spot, thank you! I'll sort that out asap!
Link to comment
Share on other sites

Hi Simon, nice work my friend, but it looks like you have your neck seal on backwards in the bucket off photo.

Any chance I can get you to kit up again and re take that photo so we know you do wear it correctly please.

 

Thanks for your patience and we will be with you as soon as possible.

Link to comment
Share on other sites

Hi Simon, nice work my friend, but it looks like you have your neck seal on backwards in the bucket off photo.
Any chance I can get you to kit up again and re take that photo so we know you do wear it correctly please.
 
Thanks for your patience and we will be with you as soon as possible.
No problem, I'll be kitting up for a troop on Monday so will take that picture then!

Thanks
Link to comment
Share on other sites

How did I miss your EIB app? ;-)
 
Best of luck, mate. :-)
 
Dan
Finally got round to it over the Christmas break I think it was seeing your new signature inspired me actually haha!

Thanks!
Link to comment
Share on other sites

Hi Simon, nice work my friend, but it looks like you have your neck seal on backwards in the bucket off photo.
Any chance I can get you to kit up again and re take that photo so we know you do wear it correctly please.
 
Thanks for your patience and we will be with you as soon as possible.
Kitted up for a troop today and took the picture for you
a79e5997bc0de6dcadfd16966aada62f.jpg
  • Like 1
Link to comment
Share on other sites

Working on your application now Simon, can you please add an image of the rear of your blaster showing the D ring.

Link to comment
Share on other sites

Hey Simon, welcome and thank you for applying for EIB. Let's take a look your armor.

CRL and EIB Application Requirements:

All the required submission photos have been posted. Without further delay,  your armor displays all the necessary elements to qualify for Expert Infantry. Ukswrath and myself  would like to welcome you to Expert Infantry. Congratulations trooper      :salute:

 

Other-Armor Fit/Assembly:

In this section we review observations made by your fellow troopers and ourselves. Some observations may lead to suggestions to improve the overall look of your armor. If any suggestions may affect the application process, it will be listed separately in either the above EIB or below Centurion requirement sections. You look great, but we do have a few suggestions to get you looking even closer to screen accurate.

 

We shall start with your shoulder bells. These can still come in closer to the chest plate and the top of the Bells should virtually touch the plastic shoulder bridges.

Also on this same image, I'm not sure if its just the camera angle but the Bicep cover strips look like they go past the bottom of the biceps themselves. If this is the case maybe sand them down o touch.

 

PS3Vzca.jpg

 

image.png.ac544bef6416d5a8d261349fe194d060.png

 

Your Thermal det looks great, but if you want to take it that little bit further you can use Pan head screws as opposed to the dome head, for the ultimate screen accuracy.

WFRSR7v.jpg

 

image.png.e285166180a49dfd2f4d983634767a2c.png

Centurion Suggestions or Requirements:

In this section we prepare you for Centurion. If there were any areas of concern they would be discussed here. We are please to say we can't see anything that stands out here. Make sure you add photos of your belt laid out flat, both front and rear so we can see the drop boxes have backs and also the way everything is mounted to it. also make sure those drop boxes are in line with the ends of the plastic ammo belt.

Congratulations once again trooper. :duim:

 

  • Like 1
Link to comment
Share on other sites

Hey Simon, welcome and thank you for applying for EIB. Let's take a look your armor.

CRL and EIB Application Requirements:

All the required submission photos have been posted. Without further delay,  your armor displays all the necessary elements to qualify for Expert Infantry. Ukswrath and myself  would like to welcome you to Expert Infantry. Congratulations trooper      :salute:

 

Other-Armor Fit/Assembly:

In this section we review observations made by your fellow troopers and ourselves. Some observations may lead to suggestions to improve the overall look of your armor. If any suggestions may affect the application process, it will be listed separately in either the above EIB or below Centurion requirement sections. You look great, but we do have a few suggestions to get you looking even closer to screen accurate.

 

We shall start with your shoulder bells. These can still come in closer to the chest plate and the top of the Bells should virtually touch the plastic shoulder bridges.

Also on this same image, I'm not sure if its just the camera angle but the Bicep cover strips look like they go past the bottom of the biceps themselves. If this is the case maybe sand them down o touch.

 

PS3Vzca.jpg

 

image.png.ac544bef6416d5a8d261349fe194d060.png

 

Your Thermal det looks great, but if you want to take it that little bit further you can use Pan head screws as opposed to the dome head, for the ultimate screen accuracy.

WFRSR7v.jpg

 

image.png.e285166180a49dfd2f4d983634767a2c.png

Centurion Suggestions or Requirements:

In this section we prepare you for Centurion. If there were any areas of concern they would be discussed here. We are please to say we can't see anything that stands out here. Make sure you add photos of your belt laid out flat, both front and rear so we can see the drop boxes have backs and also the way everything is mounted to it. also make sure those drop boxes are in line with the ends of the plastic ammo belt.

Congratulations once again trooper. :duim:

 

That's great news first thing in the morning, thanks!
Can I ask what's the best way to move the shoulder bells in? Or should I put that question on a WIP?
  • Like 1
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...