Solcar23[TK] Posted August 15, 2016 Report Share Posted August 15, 2016 Well, I'm fresh off posting my EIB status and I figured I'd be pro-active and get this ball rolling too. Here's my submission for Centurion status for my Anovos build. Thank you in advance for your consideration! Ok, then........(holds breath)....here we go: Name: Carlos MendozaLegion ID: TK 5924Forum Name: Solcar23Garrison: Midwest Garrison501st Member Page: http://www.501st.com/members/displaymemberdetails.php?userID=14790Height: 5'9"Weight: 175Armor maker: AnovosHelmet maker: AnovosBlaster: Doopydoos full kitCanvas Belt: GazmosisHolster: GazmosisHand Plates: Latex/TrooperbayElectronics: Icomm voice changer/ AkerBoots maker: TK Boots/Size 11Neckseal: Anovos And now the pictures............ Front - Arms at side: Back - Arms at side: Left - Arm raised: Right - Arm raised: Right side detail: Right side "Han" snap, as it didn't come through in the above pictures: Left side detail: Rubber Gloves and Latex Hand Plates: Shoulder bridge back w/elastic: Shoulder bridge front: Back to chest connection: Thigh Pack attachment: Knee Plate front: Knee Plate right side: Knee Plate left side: Drop Box backs: Cod to Butt Plate attachment: Ab Detail: Interior Strapping: Kidney Plate notch - right side: Kidney Plate notch - left side: Wrist side of forearms: As stated in my EIB thread: I did a redo of the lid following Gazmosis' post on the subject. The frown has been repainted, correct screws installed, its pop riveted together, better fitting and more accurate brow trim, the tube stripes are Trooperbay decal replacements for the decal that was there. The lenses were also custom cut and installed as per Gaz's post, using hockey helmet screws embedded in abs stacks. The helmet is also Plasti-Dipped on the inside with MICH pads for support. Helmet - front: Helmet - left side: Helmet - right side: Helmet -back Hovi-Mic Tip detail (upgraded): Lens color: S-Trim: Frown repaint, right point: Frown repaint, left point: Helmet interior: Blaster - left side (?): Blaster - right side (?): Blaster D-ring attachment: Canvas belt front: Canvas belt back: Holster attachment: Neck seal: Thermal Det back w/correct painted screws: Action Pose 1: Action Pose 2: Obligatory lid off: Thank you for your consideration....fingers crossed...... 1 Quote Link to comment Share on other sites More sharing options...
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.