Pyrates[TK] Posted March 14, 2017 Author Report Share Posted March 14, 2017 Back Plate - Centurion requirements: •Back plate shall have no, or minimal overlap of the kidney plate. - ✔️ •AM chest plate must be replaced with a more screen accurate version. - Not applicable Reference Photo: My back plate: Quote Link to comment Share on other sites More sharing options...
Pyrates[TK] Posted March 15, 2017 Author Report Share Posted March 15, 2017 (edited) Abdomen Armor: EIB requirements: •Any gap between the abdomen and kidney armor is no more than 1/2" (12.5mm) wide. - ✔️ •Any shims used to achieve this effect are of a similar material and color as the abdomen and kidney armor. Shims fit flush and seams are allowed. - NOTE*AP armor comes with abdomen extensions on both the kidney and abdomen plates that you can trim to your needs without having to install shims - ✔️ Reference Photos: My Abdomen Plate: Centurion requirements: •Ideally there no gap between the abdomen and kidney armor. - ✔️ •A single visible seam line is present. - ✔️ •Three rivets, approximately 5/16"(8mm) diameter, are present on the left side of the abdomen armor. - ✔️ Note: The original rivets used for the TK armor were bifurcated rivets or split rivets. Rivets are equally spaced along the depth of the armor and about 10mm from the edge. The heads are rounded or domed. Note: Paperclip brads are not considered to have a domed head. Reference Photo: •Rivets are painted white. - ✔️ •A single split rivet or brad is present on the lower tab of the abdomen armor. - ✔️ Reference Photo: My lower tab: •A single male snap on the top right corner of the ab plate is present. Rivet does not need to be functional. - ✔️ Reference Photo: •Abdomen armor buttons are integrated and painted directly on the armor. No separate buttons are allowed. - ✔️ Reference Photos: My Abdomen Buttons: Edited March 15, 2017 by Pyrates Quote Link to comment Share on other sites More sharing options...
justjoseph63[Staff] Posted March 15, 2017 Report Share Posted March 15, 2017 One set from JustJoseph63 - which can be obtained from our "On-Going" sales forum here: I intend to get his "Alternative Style/ Hero Guards" as a later upgrade as funds are a bit tight at the moment. I'll bring a set of the white silicone "Alternative" hand guards to give to you at C8, Aaron. It's the least I could do for all your work on the racing shirt run. (Just remind me a week ahead of time). 1 Quote Link to comment Share on other sites More sharing options...
Pyrates[TK] Posted March 15, 2017 Author Report Share Posted March 15, 2017 (edited) I'll bring a set of the white silicone "Alternative" hand guards to give to you at C8, Aaron. It's the least I could do for all your work on the racing shirt run.Thank-you very kindly Joseph !!! And will do! Edited March 15, 2017 by Pyrates Quote Link to comment Share on other sites More sharing options...
justjoseph63[Staff] Posted March 15, 2017 Report Share Posted March 15, 2017 Troopers helping Troopers who help other Troopers, bro. 1 Quote Link to comment Share on other sites More sharing options...
Pyrates[TK] Posted March 15, 2017 Author Report Share Posted March 15, 2017 Troopers helping Troopers who help other Troopers, bro. WHOOO-WAHHH! 1 Quote Link to comment Share on other sites More sharing options...
Pyrates[TK] Posted April 5, 2017 Author Report Share Posted April 5, 2017 Alright time to wrap this thread up... Kidney Plate - Centurion requirements: •Cut-out notches at the bottom of right and left sides of the Kidney Armor are optional. If present, each notch is approximately 22 mm tall and the back of the notch ideally is aligned with the front edges of the Posterior Armor plate. - ✔️ Reference Photos: My Kidney Plate: •Three rivets, approximately 5/16"(8mm) diameter, are present on the left side of the kidney plate. Note: The original rivets used for the TK armor were bifurcated rivets or split rivets. Rivets are equally spaced along the depth of the armor and about 10mm from the edge. The heads are rounded or domed. Note: Paperclip brads are not considered to have a domed head. - ✔️ Reference Photo: My Kidney Plate: Rivets are painted white. - ✔️ 1 Quote Link to comment Share on other sites More sharing options...
Pyrates[TK] Posted May 11, 2017 Author Report Share Posted May 11, 2017 My apologies for the delay - Celebrations and Expos happen Posterior Plate (Butt Plate) - EIB requirements: •Two male snaps are present on the lower center tab of the Posterior Armor. Snaps do not need to be functional. - ✔️ Reference Photo: My Posterior Plate: Quote Link to comment Share on other sites More sharing options...
Pyrates[TK] Posted May 11, 2017 Author Report Share Posted May 11, 2017 The Waist Ammo Belt - EIB requirements: •There shall be three square buttons, one centered in the middle and one on each end of the plastic ammo belt. - ✔️ Reference Photos: ***It's also good to take notice where the belt sits on the Abdomen Plate near the buttons to make sure your belt is sitting at the proper height*** My Waist Ammo Belt: Centurion requirements: •Drop boxes must have full inner drop boxes to close the back. Flat covers are not allowed. - ✔️ Drop boxes are vertically aligned with the end of the ammo belt with minimal gap between belt and box. - ✔️ The corners of the plastic ammo belt shall be trimmed at a 45 degree angle. - ✔️ Reference Photos: My Waist Ammo Belt: Quote Link to comment Share on other sites More sharing options...
Pyrates[TK] Posted May 12, 2017 Author Report Share Posted May 12, 2017 Thermal Detonator - EIB requirements: •Thermal detonator belt clips are positioned with little to no gap between the clips and the end caps. - ✔️ Reference Photo: My Thermal Detonator: Quote Link to comment Share on other sites More sharing options...
Pyrates[TK] Posted May 15, 2017 Author Report Share Posted May 15, 2017 Thigh Armor - EIB requirements: •Thigh ammo belt is attached to thigh with a solid head rivet or fastener in the upper corner and fastened to the lower thigh ridge. The solid head rivet attachment is painted white. - ✔️ *Standard pop rivets are not allowed The bottom corners of the thigh ammo belt are rounded off. - ✔️ Reference Photos: My Thigh Armor: Centurion requirements: Thighs are constructed using the butt joint and cover strip method. - ✔️ *Overlap construction is not allowed. Reference Photos: My Thigh Armor: Quote Link to comment Share on other sites More sharing options...
Pyrates[TK] Posted May 16, 2017 Author Report Share Posted May 16, 2017 Lower Leg Armor - EIB requirements: Sniper knee plate is aligned with the ridges on the shin. - ✔️ *Sniper knee plate does not have visible rivets or fasteners attaching it to the shin. Reference Photos: My Lower Leg Armor: Centurion requirements: Lower legs are constructed using a butt joint and cover strip method. - ✔️ *Overlap construction is not allowed. Reference Photos: My Lower Leg Armor: Quote Link to comment Share on other sites More sharing options...
Pyrates[TK] Posted May 16, 2017 Author Report Share Posted May 16, 2017 And finally... Boots! EIB requirements: •There is no seam present on the front of the boot. - ✔️ Reference Photo: My Boots: Quote Link to comment Share on other sites More sharing options...
Pyrates[TK] Posted May 16, 2017 Author Report Share Posted May 16, 2017 Now with all the requirements met, there is one trick from Tony (Ukswrath) I wanted to share from my original build thread, and no doubt my freaking savior. I'm OCD on trying keep my armor looking as new as possible and wanted to clean it up before taking submission photos. After multiple troops your armor acquires its battle damage - scuffs, scratches, black marks from Vader knows what. In my case one serious 1/16" gouge in my Waist Ammo Belt. Thank you a million times over Tony for telling me about this... The 3M HEADLIGHT RESTORATION SYSTEM Now due to being in my neck of the woods, my kit didn't come with a drill attachment so I made my own - break out the McGyver theme music (Rubber Isolation Pad for air conditioning) Quote Link to comment Share on other sites More sharing options...
Pyrates[TK] Posted May 16, 2017 Author Report Share Posted May 16, 2017 Here's a before picture: And after using Novus 3 Heavy Scratches, then Novus 2 Light Scratches, then the 3M Buffing Compound that comes with the kit. After all of that I sprayed Novus 1 Revitalizer to clean everything up. Quote Link to comment Share on other sites More sharing options...
Pyrates[TK] Posted May 16, 2017 Author Report Share Posted May 16, 2017 Here's the after photo: Quote Link to comment Share on other sites More sharing options...
Pyrates[TK] Posted May 16, 2017 Author Report Share Posted May 16, 2017 And finally a comparison photo: Quote Link to comment Share on other sites More sharing options...
Pyrates[TK] Posted May 16, 2017 Author Report Share Posted May 16, 2017 To remove all your black marks from your armor BEFORE polishing use Mr.Clean Magic Erasers Quote Link to comment Share on other sites More sharing options...
Pyrates[TK] Posted May 16, 2017 Author Report Share Posted May 16, 2017 Gentle reminder to all that you must apply for your EIB qualification BEFORE you apply for Centurion. Taking all the photos you need has been made easy peasy thanks to Star Raider TK - 4524, and can be found here: http://www.whitearmor.net/forum/topic/22604-expert-infantry-application-photo-checklist/#entry544510 Quote Link to comment Share on other sites More sharing options...
Pyrates[TK] Posted May 16, 2017 Author Report Share Posted May 16, 2017 (edited) It's extremely helpful if you have a fellow member assist you while taking your photos to make sure you're looking your best. I encourage fellow troopers to get in touch with their local Attaché to see if they can come help. If you don't know who your local Attaché is then they can easily be found thanks to "justjoseph63" TK - 10963 in the link below: http://www.whitearmor.net/forum/topic/38483-fisd-imperial-attache-list/ Edited May 16, 2017 by Pyrates Quote Link to comment Share on other sites More sharing options...
Pyrates[TK] Posted May 16, 2017 Author Report Share Posted May 16, 2017 (edited) Once you submit your photos, then it's just like when you first applied to the 501st. Our freaking stellar Deployment Officers will be with you as quickly as they can to guide you along to the path to Centurion. Edited May 16, 2017 by Pyrates Quote Link to comment Share on other sites More sharing options...
Pyrates[TK] Posted May 16, 2017 Author Report Share Posted May 16, 2017 (edited) Once you receive your EIB number, you can then get your Centurion application under way - after any corrections that need to made. The Centurion Photo checklist can be found here, thanks again to "Star Raider": http://www.whitearmor.net/forum/topic/22605-centurion-application-photo-checklist/ Edited May 17, 2017 by Pyrates Quote Link to comment Share on other sites More sharing options...
Pyrates[TK] Posted May 16, 2017 Author Report Share Posted May 16, 2017 (edited) Now to close this thread out in Pyrates fashion... https://youtu.be/KNjhiGHpaGU I owe many profound thanks to (and in no particular order): My Attaché Boss - justjoseph63 Marc - CTID Andrew - Sly11 Tony - Ukswrath Tim - DarkCMF Paul - Daetrin - The Boss Mathias - Locitus Brad - 68Brick Dan - TK-2759 Kris - Haso Steve - starsaber25 Jorge - zv288bot James - Kaar121 Gary - Sentry71 Spencer - Jinsei Preston - Pretzel Dave - ComradeDave The entire Badlands Garrison "My TK Twin" Teresa - Soulart And last but definitely not least my brother in Arms Peter - Barcode Many appreciative thanks again to you all for your support, encouragement, leadership and camaraderie - chest thumps and a TK fist raised high in your names. Rock on my fellow Troopers - Rock on! Edited May 16, 2017 by Pyrates Quote Link to comment Share on other sites More sharing options...
Troopacoola[TK] Posted May 16, 2017 Report Share Posted May 16, 2017 Now to close this thread out in Pyrates fashion... https://youtu.be/KNjhiGHpaGU I owe many profound thanks to (and in no particular order): My Attaché Boss - justjoseph63 Mark - CTID Andrew - Sly11 Tony - Ukswrath Tim - DarkCMF Paul - Daetrin - The Boss Mathias - Locitus Brad - 68Brick Dan - TK-2759 Kris - Haso Steve - starsaber25 Jorge - zv288bot James - Kaar121 Gary - Sentry71 Spencer - Jinsei Preston - Pretzel Dave - ComradeDave "My TK Twin" Teresa - Soulart And last but definitely not least my brother in Arms Peter - Barcode Many appreciative thanks again to you all for your support, encouragement, leadership and camaraderie - chest thumps and a TK fist raised high in your names. Rock on my fellow Troopers - Rock on! Now to get those beauties framed! Sent from my SM-G920F using Tapatalk 1 Quote Link to comment Share on other sites More sharing options...
Pyrates[TK] Posted May 16, 2017 Author Report Share Posted May 16, 2017 Now to get those beauties framed! Sent from my SM-G920F using Tapatalk Cheers mate and will do! 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.