humperdingle Posted May 26, 2016 Report Share Posted May 26, 2016 The two little 'C' shaped parts (For front of ejection port and blast hider at muzzle)<br><br> Which part goes where? One is slightly longer than the other.<br><br> And how do you folks keep the front part of the folding stock anchored?<br><br> Ta Quote Link to comment Share on other sites More sharing options...
clown3y[TK] Posted May 26, 2016 Report Share Posted May 26, 2016 Hi Mark! I used the slightly larger one for the shell ejection port and attached the smaller one to the front. I simply sanded the "front" section of the stock a bit and then glued it onto the tube with E6000. Holds perfectly 1 Quote Link to comment Share on other sites More sharing options...
themaninthesuitcase[Admin] Posted May 26, 2016 Report Share Posted May 26, 2016 I binned my DD flash guards and used some 3D printed ones. For the front stock I added a screw to fit into the slot which is molded in but needs filing out. Quote Link to comment Share on other sites More sharing options...
TK bondservnt[501st] Posted May 26, 2016 Report Share Posted May 26, 2016 I use the wide one for the ejection port and the smaller one for the front. They are called "standoffs" for putting the weapon on a wall sideways. The front folding stock. I use a large rivet pin, which is glued to the front at the exact location for the lock. then I simply glue. At the mid point of the folding stock I use a screw and glue countersunk into the hole. Fill and paint. Quote Link to comment Share on other sites More sharing options...
humperdingle Posted May 26, 2016 Author Report Share Posted May 26, 2016 Ok folks, thanks. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.