TKDMAC74 Posted March 24, 2015 Report Share Posted March 24, 2015 So been looking at threads on Centurion Builds and ab buttons are 7/16 but does plate but up against edge or in a little also rounded corners? Thanks everyone Quote Link to comment Share on other sites More sharing options...
TKDMAC74 Posted March 24, 2015 Author Report Share Posted March 24, 2015 Quote Link to comment Share on other sites More sharing options...
R4ZORBL4DE[TK] Posted March 24, 2015 Report Share Posted March 24, 2015 Ā Quote Link to comment Share on other sites More sharing options...
TKDMAC74 Posted March 24, 2015 Author Report Share Posted March 24, 2015 Joe, follow TK-1650 diagram even round edges? Quote Link to comment Share on other sites More sharing options...
Bone[TK] Posted March 24, 2015 Report Share Posted March 24, 2015 No round Corners: Ā Ā http://www.whitearmor.net/forum/gallery/image/921-ab-plate-04jpg/ Quote Link to comment Share on other sites More sharing options...
SCTrooper[TK] Posted March 25, 2015 Report Share Posted March 25, 2015 Square up the corners like this. 7/16 is about right for the buttons. Quote Link to comment Share on other sites More sharing options...
gazmosis[501st] Posted March 25, 2015 Report Share Posted March 25, 2015 YOu can even take it closer to the edge for more secure gluing surface. Just do not exceed the rounded portion of the edge. Quote Link to comment Share on other sites More sharing options...
justjoseph63[Staff] Posted March 25, 2015 Report Share Posted March 25, 2015 Boy did I learn my lesson on this one!Ā Even after all my research, I glued both plates on, thinking because they were "pre-trimmed", they were good to go.Ā Took me over 2 hours to remove, trim to the correct size, and then re- glue them.Ā Needless to say there was a fair amount of mild cursing. Quote Link to comment Share on other sites More sharing options...
Mutter[TK] Posted March 25, 2015 Report Share Posted March 25, 2015 Welcome to the club! I trimmed mine too much, used it to get through 501 acceptance and EIB and then replaced it for Centurion. oopsies Quote Link to comment Share on other sites More sharing options...
TKDMAC74 Posted March 25, 2015 Author Report Share Posted March 25, 2015 Quote Link to comment Share on other sites More sharing options...
TKDMAC74 Posted March 26, 2015 Author Report Share Posted March 26, 2015 How do we look now? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.