inquisitot785 Posted September 12, 2014 Report Share Posted September 12, 2014 What methods do you prefer for trimming/cutting eyes-teeth out on ABS kits? Do you prefer scoring and snapping, using scissors or dremeling out openings? Or all three? Thanks, Inquisitot785 Jim Quote Link to comment Share on other sites More sharing options...
ABS80 Posted September 12, 2014 Report Share Posted September 12, 2014 (edited) On all my armor parts I use the scoring/snap method, much faster, edges come out nice and perfect. For the teeth the easiest and fastest method is using a dremel and sand down the bumps from inside helmet until perforated then square off the teeth using exacto, for the eyes I use a dremel with cutting disc again from the inside, then clean edges using exacto and sanding paper. Mark (AP) Edited September 12, 2014 by ABS80 1 Quote Link to comment Share on other sites More sharing options...
Grimez Posted September 12, 2014 Report Share Posted September 12, 2014 For the eyes I scored along the edge then drilled some holes in them then cut the rough shape out. Then I snapped out the rest of it and sanded it down to about an inch. For the teeth I drilled one or two holes in each then shaped them with an exacto knife. Quote Link to comment Share on other sites More sharing options...
bzb Posted September 12, 2014 Report Share Posted September 12, 2014 (edited) My first kit, I did all with box cutter and x-acto, and some shears for the really large, thick parts. Dremel for the eyes and X-acto to finish eyes and teeth. My second bucket, I used box cutter to rough in, dremel to finish. Teeth roughed in with X-acto and finished with jeweler's files. Current kit, using box cutter to rough in, dremel to finish the curves. Box cutter and metal ruler to snap the straight lines. 150 grit paper to reduce armor bites. Edited January 14, 2021 by gmrhodes13 photo updated gmrhodes13 2021 Quote Link to comment Share on other sites More sharing options...
Dark CMF[Staff] Posted September 12, 2014 Report Share Posted September 12, 2014 I used score and snap to remove the "fill-in" of the eyes, and that's the only spot for the bucket. Everything else on the bucket was Exacto, Box-Cutter, Hobby files, and Sandpaper. Quote Link to comment Share on other sites More sharing options...
Superkav Posted September 13, 2014 Report Share Posted September 13, 2014 For teeth I drilled a small pilot hole then opened up the shape with a 3 sided modelling file. Nice sharp corners and you can go a bit wonky/sharp like they're supposed to be Sent from my iPhone using Tapatalk Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.