Jump to content

Killerbee658

Member
  • Posts

    1
  • Joined

  • Last visited

About Killerbee658

Standard Info

  • Name
    ERIK
  • 501st Unit
    Northeast remnant
  1. Hello all! I'm not sure if this is where I should post this but, I've been planning to build my own 3d printed sterling smg to convert it into an e11 blaster and I wanted it to have a functional scope. The problem comes when I try to either replicate or buy a scope. Either the scope is too expensive or there aren't any in stock so I took apart a telescope I had laying around and 3d printed the scope instead but the problem with that is that the image is upside down, I did mu research and found most scopes use a prism and while the telescope came with one, it wasnt the right one I needed. As many of you may know the scope for the e11 is really small and trying to find a compatible system of lenses and prisms for the scope to function like the real deal is a challenge. Can anyone point me to the right direction with either a fairly cheap set (less than 25 preferably) or a blueprint of the scope including the prism holder and the prisms themselves? Any and all comments would be very much appreciated. Thank you all for your time!
×
×
  • Create New...