-
Posts
78 -
Joined
-
Last visited
Content Type
Profiles
Forums
Gallery
Articles
Media Demo
Posts posted by Darth147
-
-
the putty does remove the primer sometimes
happens to me all the time but doesn't cause any actual issues once sanded
- 1
-
-
did the final coat of white gloss om some parts and gave it a few coats of clear gloss
decided to paint the chest instead of doing another coat of primer
- 1
-
-
Can’t wait to see your result
-
you should be good
if anything you can re sand a bit since most paint is paint and primer
which orientation did you print at
i gave up with the helmet for now until i get the rest of the suit done
-
i suggest you prime and sand until your happy with that you see
once your done with all your sanding and you prime a final time and if you do not notice anything wrong
do a wet sand of 2000 grit and then paint
the intended part where the mic tips go never fully closes
-
you can for an extra shine
just make sure you do not wait more than a hr after your last coast to apply the clear coat
i also started the nico bucket but have had trouble printing the chin
- 1
-
I wouldn’t use it
gloss white paint should be enough
- 1
-
its best to paint the bucket and spray the clear coat 30 mins after your last coat of paint
if you wait more than 24hrs it has a weird chemical effect
- 1
-
used a razor to try and bring out the details of the cover strips
will try DarthBiscuits idea of filling some of the pinholes with a paint brush and re sand
and give the notches a touch up
- 1
-
painted a few more parts
had some runs
looks good from a far
- 2
-
sanded off the jb weld and a good chunk of it fell off
used resin and fiber glass sheet to repair
will sand off tomorrow
-
What did you use to dry it with
I use a microfiber cloth
-
wet sanded the parts i had put bondo putty on
my lil helper accidently dropped one of the ammo boxes and a good chunk broke off
used some JB weld to fill and repair works pretty good for cracks as well
used it to repair the cracks i had on the chest and back
just a bit
it sands off with some elbow grease
you can see on the bottom middle section of the chest a crack that has been filled and repaired
-
The plasti dip will come off if you try to sand it
I don’t recommend sanding
you should be able to peel the whole thing off easily and paint again if you need to
- 1
-
got to paint some parts
the clear coat kinda messed it up a bit leaving some drop marks nothing too noticeable
not perfect but i am not going to beat myself up about it too much
- 2
-
-
use some fiberglass sheet to make the thighs stronger where there where soft spots
i would be able to push though it with my fingers after this no more
-
Awesome!
i seen 3D files for a R1 armor out there but I can’t justify spending 150 on them right now since I already have a R1 kit
-
Ived noticed from what Ived seen that nobody gets the white to match the same color of the abs
-
with a 850aw kit your going to have to paint it all if you want the color to match the greeblies so either way your going to paint
- 1
-
the sanding never ends
- 3
-
need to cover a lot of pinholes on the thighs
fill sand prime and repeat until its good
- 1
DarthBiscuit's R1TK Build (Jimmiroquai kit)
in Rogue One Build Threads
Posted
i cut a lot of the top of my barrel due to it hitting my chest too much and preventing me from leaning forward or bending down