Jump to content

tgoldner76

501st Stormtrooper[TK]
  • Content Count

    37
  • Joined

  • Last visited

About tgoldner76

  • Rank
    Corporal
  • Birthday 08/07/1976

Profile Information

  • Gender
    Male

FISD Info

  • FISD Supporter
    No

Standard Info

  • Name
    Troy
  • 501st ID
    20187
  • 501st Unit
    Thylacine Outpost

Recent Profile Visitors

128 profile views
  1. Congrats and welcome to the Legion Trooper. Sent from my SM-G960F using Tapatalk
  2. Congrats Trooper, it's been great to be able to follow you from build to approval. Sent from my SM-G960F using Tapatalk
  3. That's Awesome, we'll done Trooper Sent from my SM-G960F using Tapatalk
  4. Looks amazing. Sent from my SM-G960F using Tapatalk
  5. Congrats Trooper. Sent from my SM-G960F using Tapatalk
  6. Welcome aboard trooper Sent from my SM-G960F using Tapatalk
  7. I agree, the rest looks great. Hopefully they used e6000 (or similar) to glue the pieces and it should be relatively easy to break them down, tidy up and glue back together. Good luck. Sent from my SM-G960F using Tapatalk
  8. I'd also grab a copy of Ukswraths build guide as a reference. Looking at the pics there will be a few corrections required to achieve 501st approval. Ie where the cover strips end on the top and bottom of the thighs. This a reference from my armour, note the cover strip doesn't go all the way to the edge or under the ammo pack. Sent from my SM-G960F using Tapatalk
  9. Hi Tepes, what's the width of the cover strips that have been used. For the thighs these should only be 2cm wide, from the pics they appear a lot wider. A list of cover strips are below. Strips for arm armour are 1.5 cm wide Legs 2cm, with back of shins 2.5 cm Sent from my SM-G960F using Tapatalk
  10. Looks amazing, great job. Sent from my SM-G960F using Tapatalk
  11. Looks amazing Steve, looking forward to trooping with you in your FOTK next time I'm in Vic. Sent from my SM-G960F using Tapatalk
  12. Congratulations Trooper and welcome to the Legion. Sent from my SM-G960F using Tapatalk
  13. Hi Keith, I believe your hand guards should be around 1/4 inch or approx 63mm high after trimming. Sent from my SM-G960F using Tapatalk
  14. Hi Michael, thanks for sharing and welcome to the Legion Trooper. Sent from my SM-G960F using Tapatalk
  15. Looking good, for comfort, it should be noted that you will never be 100% comfortable, as your walking around covered in hard plastic. To improve look for any pinch points, remove any sharp corners and adjust your strapping. This will however be a continued process as you do different troops (ie walking up hills presents different pinch points vs walking on flat surfaces). I found the back of my knees as the worse place for pinching. Based on the pics you Biceps look ok, I'd just make sure you have enough movement between your Bicep and Forearm Arm. Once you have your gloves on you may find you hand guard hitting your Forearm armour for example. I'd also suggest putting your boots on to see if your Calves sit higher, which will give you a guide as to the gap between your thigh and calves, which may then led to you wanting to add the half moons on the Thigh/Calves behind your knees.
×
×
  • Create New...