Crimson Phoenix

I'm going to see if I can find a more comfortable way to fit the shoulder bells. I tried the one strap technique. Not very fun. I already have straps connecting my ab and kidney plates. Should I just make them tighter then?

Yeah with snaps and velcro.

How to apply my holster to my canvas belt? A picture tutorial would be appreciated. THANKS~!

So,I have this really annoying problem with my left leg. The back of my shin and thigh squeeze together, and give me horrible pain from it. Is there any way I can trim down my shins alittle bit, or cut off some of the lip and still remain accurate?

Ok... so apparently RadioShack has gotten rid of all it's voice amplifiers? Can someone please tell me where I locate one? Mostly cause for now this is cheaper than buying a ROM/FX. + hovies + wires + etc...

This was merely a test fitting. And I pinched my bloody leg again. That was the last straw. I'm trimming that leg tonight if I can.

................ ................................ .............. <_< ...lame'd

NUH UH!

I don't have any pictures of it yet, but my armor is DONE~! My armor being complete should be up here by tonight, when the E600 finishes drying.

I'm not sure why, but I look very pissed off in this picture? Perhaps it's cause my shin broke again.... Just goofing off at this point.

Measure twice, cut once.

We used pop rivets to attach the knee cap. So much easier, I should probably get one. Here.... my shin snapped under the pressure of the CA glue. Boo.. :[ The clamp jungle and this is the mysterious clamp crotch spider. only seen in garages of of North America. Yeah, I had someone help me size my shoulder bells later that night after I left Luke's. Now I have to pull out that sewing machine again or make new straps for my shoulders.

Next was the split rivets for the kidney and ab plates.

A step by step of how to make snaps. and there you have it. A snap.