REQUIREMENTS

Stormtrooper Detachment Elite Base Standards
  • Armor Details
    • White Stormtrooper armor, made in ABS, HIPS, or fiberglass.
    • Black Gloves made of rubber, leather, or leather like material
    • Black undersuit, either one-piece or two piece. Non-textured material. Commonly used items include “UnderArmor” or “Starter” warm-up suits, or dance unitards.
    • White, ankle high, laceless, Stormtrooper boots. The boots are usually made from leather or vinyl, with small U-shaped elastic sections on either side of the ankle, and an approx. 1” heel.
    • Drop boxes (small rectangular parts attached to stormtrooper’s belts, above the thigh), connected to the belt via white straps
    • Thermal Detonator (aka O2 Cannister) center mounted on the back of the belt
    • "Buttons and ridges" ab plate, as opposed to the flat rectangular ab plate of sandtroopers
    • Polygon knee plate mounted on the left shin, as opposed to the diamond knee plate of sandtroopers
    • Ribbed shoulder straps
    • Black ribbed neckseal. The ribs should be horizontal, not be loose, and should extend from the base of the neck to the top of the adam's apple.
    • Correctly colored and sized ab plate buttons. Buttons are approximately 7/16" in diameter.
    • No visible rivets on shoulder straps
    • Belt should be canvas or canvas covered, approximately 3" wide.
    • Seperate kidney and butt pieces rather than a single back piece. Cut should be visible below the belt.
    • Side gaps must be closed.
      • IDEAL: The ab and kidney plates touch.
      • PREFERRED: A shim can be used to bridge the gap. Ideally shims will be added in a seamless fashion to the ab/kidney plates to emulate these parts of the armor meet in the middle.
      • ALLOWED: Currently the use of a non-plastic shim is allowed to fill the gap. This is the least preferred method and may be dis-allowed in the future.Ideally the ab plate and kidney plates should touch, though at this time the use of a spacer or shim is permissable.
  • Helmet Details
    • Black Hovi-Mix cast “tusks”
    • Blue tube stripes
    • IMPORTANT: FX helmets are NOT considered acceptable for Elite qualification.
  • Blaster Details
    • Scratch-built, resin cast, hyperfirm rubber cast, or modified toy blaster.
    • T-tracks on blaster (total of 6)
    • Ammo Magazine
    • Folding stock (does not need to function)
    • Scope
    • D-Ring on the end

Reference Image





Detachment Stormtrooper Approved Options
The following modifications are required
  • FX Helmets are not longer acceptable for Elite qualification