ANH Details

To quality for ANH EIB recognition, a trooper will...

MUST HAVE

  • Comply with ALL base Requirements

Armor Details

  • Must meet all the requirements of the base armor
  • Holster is worn on the left
  • Holster must be attached to the belt from behind instead with no loops covering the outside of the belt
Ab Button :: Color Guide Separate kidney and butt plates :: instead of a single back plate Canvas or canvas covered :: Holster attached from behind with no loops covering the outside. Approximately 3 inches wide There must be no significant gap between the ab and kidney plates. :: IDEAL: The ab and kidney plates touch. PREFERRED: A shim can be used to bridge the gap. Ideally shims will be added in a seamless fashion to the ab/kidney plates to emulate these parts of the armor meet in the middle. ALLOWED: Currently the use of a non-plastic shim is allowed to fill the gap. This is the least preferred method and may be dis-allowed in the future. There must be no visible rivets :: on the shoulder straps

Helmet Details

  • Must meet all the requirements of the base helmet
  • Grey painted frown, and paint should not touch the "lips" section
  • Grey traps / teardrops with black lines on rear traps & tears
  • Conform to either Hero or Stunt options below

Hero Configuration

  • Bubble lenses, may be smoke or green
  • Six cut teeth (3 / side) on frown
ANH :: Hero

Stunt Configuration

  • Flat green lenses
  • Eight cut teeth (4 / side) on frown
ANH :: Stunt

Blaster Details

  • Must meet all the requirements of the base blaster
  • Must include Hengstler counter on left side of weapon
  • No ESB/ROTJ style greeblies are allowed
ANH :: BlasTech E11 Blaster

SHOULD HAVE

  • Trapezoidal latex (or latex equivalent) hand guards - painted white - mounted on rubber gloves
  • For ANH Stunt, the holster will be affixed with two fasteners at the top. These may be rivets, snaps, or Chicago screws
  • For ANH Hero, the holster will be affixed with four fasteners, two at the top and two at the bottom. These may be rivets, snaps, or Chicago screws
  • Rivets on the left side of the ab/kidney plates: a total of six rivets with three on the ab and three on the kidney plate, equally spaced out along the depth of the armour and about 10mm from the edge. They may be painted white, or not

MAY HAVE

Stormtroopers may have the following

  • Grappling hook and Comlink (i)
  • DLT-19 (ii)
  • SE-14R (iii)

NOTES:

  1. The grapling hook and comlink can be substituted as a set in place of the O2 cylinder, not worn in addition to it
  2. A DLT-19 is an MG-34 that has three mods: disk on left side of pistol grip, ammo feed cover, and t-racks on the barrel
  3. This is not a 501st approved EU accessory, but is an approved EIB EU ANH accessory
Last modified on Wednesday, 30 December 2009 13:56
Read 1900 times
Published in Requirements
Social sharing
More in this category: « EIB Requirements - ESB EIB Requirements - ANH »
back to top